Third Generation F-Body Message Boards

Search: Posts Made By: NSR
Showing results 1 to 8 of 8
Search took 0.12 seconds.
Forum: Tech / General Engine
07-28-2002, 05:55 PM
Replies: 1
Views: 532
Posted By NSR

Pre-'87 vs. '87-'95 Gaskets for 350?

What's the difference in these two types of gasket sets? Is it just the rear main seal or is there different intake gaskets for the Fuel Injection?

I need to buy gaskets for my engine, its TBI...
Forum: Tech / General Engine
07-26-2002, 04:02 PM
Replies: 2
Views: 2,037
Posted By NSR

Thanks for the response. I thought there should...

Thanks for the response. I thought there should be a piece of metal in the valley but my engine doesn't have it, so I assume it's not a roller cam. Also the lofter's spin in there slots. I'm trying...
Forum: Tech / General Engine
07-26-2002, 03:27 PM
Replies: 2
Views: 2,037
Posted By NSR

Help Identifying if engine has roller cam/lifter's?

I'm rebuilding the engine on my winter vehicle. It is a '91 K5 Blazer with a TBI 350. I know the original engine had a roller cam but was told by previous owner that the engine had been replaced and...
Forum: Tech / General Engine
07-25-2002, 07:04 AM
Replies: 3
Views: 803
Posted By NSR

160 is not high. My '91 350 showed 150-160 psi...

160 is not high. My '91 350 showed 150-160 psi when I checked it. There is a great article in this month's Chevy High Performance Magazine (Crank It!, September 2002), that covers this exact subject....
Forum: Tech / General Engine
07-20-2002, 05:10 PM
Replies: 2
Views: 414
Posted By NSR

ede- thanks for the response. I know I'll only...

ede- thanks for the response. I know I'll only get an unnoticable amount of performance, but I'm doing half a dozen small things that don't cost any money in hopes of getting performance up to what...
Forum: Tech / General Engine
07-20-2002, 03:38 PM
Replies: 2
Views: 414
Posted By NSR

Head Gasket Thickness?

I have a '91 TBI 350 that I'm rebuilding, it has 8.3:1 compression and a .038" head gasket. I wanted to put a thinner head gasket in it, I was thinking .015". Would this cause any clearance problems...
Forum: Organized Drag Racing and Autocross
07-16-2002, 06:18 AM
Replies: 13
Views: 668
Posted By NSR

GT4 is an RPO code for 3.73 gears, used from...

GT4 is an RPO code for 3.73 gears, used from '78-'88. It is for both Posi and non-Posi rearends.
Forum: Organized Drag Racing and Autocross
07-03-2002, 02:10 PM
Replies: 13
Views: 668
Posted By NSR

There were non-Posi 3.73's in F-bodies from 1983...

There were non-Posi 3.73's in F-bodies from 1983 - 1986.

Axle Codes

1983
- 4JK
- 5JK
- 5KM

1984
Showing results 1 to 8 of 8


 
Forum Jump


All times are GMT -5. The time now is 01:20 AM.