Third Generation F-Body Message Boards

Search: Posts Made By: 5.0LETR
Showing results 1 to 22 of 22
Search took 0.03 seconds.
Forum: Fabrication
03-08-2013, 03:44 AM
Replies: 11
Views: 1,244
Posted By 5.0LETR

Re: Welding Help

I agree with the last comment. Check the polarity! I didn't know that I had to change the polarity on my Lincoln 180 when going back and forth between flux core and solid wire. I was confused for a...
Forum: Brakes
02-27-2013, 05:49 AM
Replies: 126
Views: 94,903
Posted By 5.0LETR

Re: Brake upgrades and wheel fitment

Hello guys, I'm looking to see if anyone has fit C6 Z06 14" 6pos brakes underneath Devino adana DV430 18x8.5 wheels? I tend to think the diameter will be ok, it's the back spacing that I'm concerned...
Forum: Interior Parts for Sale
10-21-2012, 09:33 PM
Replies: 74
Views: 2,561
Posted By 5.0LETR

Re: Parting out 85 IROC

Is that a hardtop car? Do you have the headliner available?
Forum: Interior
10-16-2012, 10:55 PM
Replies: 3
Views: 891
Posted By 5.0LETR

Re: c & c headliner

Kinda the direction I was heading. I have heard that before, but figured I would ask around to see if anyone was building aftermarket ones. I may need to buy a few as I'm more of a nuts and bolts...
Forum: Interior
10-13-2012, 05:47 PM
Replies: 3
Views: 891
Posted By 5.0LETR

c & c headliner

Hello, I recently ordered a replacement headliner for my 87 Iroc with t-tops. The headliner was not even close to the correct size. I was informed by a lady at Hawks that I have a c & c headliner,...
Forum: Electronics
09-27-2012, 09:43 PM
Replies: 3
Views: 504
Posted By 5.0LETR

Fuel pump speeds

With all of you guys help, I have wired my fuel pump after having removed my computer from my car. My new question is, does the ECM regulate the fuel pump speeds according to the demands of the...
Forum: Electronics
09-21-2012, 12:12 AM
Replies: 14
Views: 1,766
Posted By 5.0LETR

Re: Removing the computer!

Ok, that makes sense. I seen some wiring diagrams for that already. That is what I was planning on doing. Thanks for the help.
Forum: Electronics
09-20-2012, 11:31 PM
Replies: 14
Views: 1,766
Posted By 5.0LETR

Re: Removing the computer!

Not for what I'm doing. Only reason for getting rid of all the old wires is just to clean up the place a bit. What I am interested in is a complete wiring diagram of the entire car. The 3 page one...
Forum: Electronics
09-20-2012, 08:19 PM
Replies: 14
Views: 1,766
Posted By 5.0LETR

Re: Removing the computer!

You guys are awesome, but I read several times that using relays is better than running hot eleictrical leads into the car. What is your stance on this?
Forum: Electronics
09-20-2012, 12:01 AM
Replies: 14
Views: 1,766
Posted By 5.0LETR

Re: Removing the computer!

Oh ya, I meant to comment on that too. I'm good with that, I have reviewed that post berfore as well. Thanks for pointing it out though. Wish someone had an answer to whether or not the oil pressure...
Forum: Electronics
09-19-2012, 01:21 PM
Replies: 14
Views: 1,766
Posted By 5.0LETR

Re: Removing the computer!

That is a smart idea. Just one question, the oil pressure switch runs the gauge pressure right? So, will the oil pressure switch give a strong enough signal to activate the fuel pressure relay? It's...
Forum: Electronics
09-18-2012, 02:26 PM
Replies: 14
Views: 1,766
Posted By 5.0LETR

Removing the computer!

Hello all,

I have an 87 Iroc that I'm removing the computer from because I'm putting an older 350 in, along with that, I'm removing all of the associated wiring that came from the computer. I am...
Forum: Engine Swap
07-20-2012, 10:58 PM
Replies: 8
Views: 968
Posted By 5.0LETR

Re: One piece or Two piece rear main?

Thanks for your replies, I really appreciate it. I'm thinking of using the newer block, although I really have no way to find out what the deck height is. Some more research and I'm sure I can...
Forum: Engine Swap
07-20-2012, 01:30 AM
Replies: 8
Views: 968
Posted By 5.0LETR

One piece or Two piece rear main?

Hello everyone, really need some input to help make an intelligent choice here. I'm building my 87 Iroc again, new engine, trans, and rear. I'm running a very well built 700R4 and a 10 bolt with...
Forum: Interior Parts for Sale
07-02-2012, 01:49 PM
Replies: 84
Views: 2,749
Posted By 5.0LETR

Re: parting out 1988 iroc z28--tpi 5 speed 3.45 car

Do you have all power window hardware and electrical available? Thanks
Forum: Interior Parts for Sale
07-02-2012, 01:46 PM
Replies: 14
Views: 875
Posted By 5.0LETR

Re: Stripping '91 RS for drag car

How much for all power window and door parts, including wires and switches shipped to 98311. Thanks.
Forum: Interior Parts for Sale
07-02-2012, 01:40 PM
Replies: 8
Views: 706
Posted By 5.0LETR

Re: power window/lock kit

PM sent.
Forum: Engine/Drivetrain/Suspension Parts for Sale
06-26-2012, 10:41 PM
Replies: 4
Views: 647
Posted By 5.0LETR

Re: Disk Brake Rear From '91 Z w/G92 package

Is that a 10 bolt rear? What gears? I have a 87 with a 9 bolt I'm trying to replace. Will you ship? If so how much to 98311.
Forum: Interior Parts for Sale
06-26-2012, 01:11 PM
Replies: 8
Views: 706
Posted By 5.0LETR

Re: power window/lock kit

What exactly is in the kit? I ordered a universal power window and door kit but looking for the OEM door lock buttons that go next to the door handle.
Forum: Interior Parts for Sale
06-19-2012, 04:20 PM
Replies: 8
Views: 531
Posted By 5.0LETR

Re: Complete set of black seatbelts

Will you take $50 for the full set?
Forum: Interior Parts for Sale
06-16-2012, 12:20 PM
Replies: 8
Views: 531
Posted By 5.0LETR

Re: Complete set of black seatbelts

I bought a front set from a guy with a 91' yesterday, but the rears were over the shoulder belts. Mine are just lap belts. Are yours just lap belts and are you willing to sell just the rears? Thanks
Forum: Interior Parts for Sale
06-14-2012, 11:43 PM
Replies: 8
Views: 531
Posted By 5.0LETR

Re: Complete set of black seatbelts

I need a set of those that will fit an 87 T-top car. Not sure if they are all the same or not. Do they retract all the way?
Showing results 1 to 22 of 22


 
Forum Jump


All times are GMT -5. The time now is 07:05 PM.