18x10 all four corners?
#1
Junior Member
Thread Starter
Join Date: Jul 2021
Location: Minnesota
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Iroc Z
Engine: 5.7
Transmission: 700r4
Axle/Gears: Stock
18x10 all four corners?
Wondering if 18x10 with 6.29 backspacing and +20 offset will fit on my 1987 iroc all the way around. I have factory axles and brakes and its not lowered but I would like to lower it 2 inches. I have seen the thread on here with the red 3rd gen with the weld 18x10.5 all the way around but he doesn't specify the offset, and he's not factory. Any help would be appreciated.
#2
Re: 18x10 all four corners?
I have 18x10 +6mm. 5.74 bs. With 295/35 tires.
All stock suspension and brakes. (Drum rear).
Hammered the front inner of rear wheel well and had clearance a little in front and behind the front wheel lip/ground effects. At full lock mine will just barley touch the inner wheel well behind the front tires.
All stock suspension and brakes. (Drum rear).
Hammered the front inner of rear wheel well and had clearance a little in front and behind the front wheel lip/ground effects. At full lock mine will just barley touch the inner wheel well behind the front tires.
The following users liked this post:
Jaysz28 (07-18-2021)
Thread
Thread Starter
Forum
Replies
Last Post
matchstick
Suspension and Chassis
3
07-27-2002 10:34 AM