Billet Specialties Wheels 15x10
#1
Senior Member
Thread Starter
Billet Specialties Wheels 15x10
Hey guys has anybody has 5 any luck fitting a set of 15x10 5.5" BS single beadlock street lite wheels with LS1 rear brakes?? If no dice on those I guess I could always go for the 17" version and be done with it. Thanks.
#3
Senior Member
Thread Starter
Re: Billet Specialties Wheels 15x10
#4
Senior Member
iTrader: (12)
Re: Billet Specialties Wheels 15x10
i believe most 3rd gen width rear's use a 5.5" backspace on a 15x10. you can double check fitment charts from Weld to be sure. I had to cut out the bumpstops and get fully adjustable rear control arms and panhard to get the rear axle centered to stop the rubbing with 275/60s
#5
Senior Member
Thread Starter
Re: Billet Specialties Wheels 15x10
i believe most 3rd gen width rear's use a 5.5" backspace on a 15x10. you can double check fitment charts from Weld to be sure. I had to cut out the bumpstops and get fully adjustable rear control arms and panhard to get the rear axle centered to stop the rubbing with 275/60s
#6
Supreme Member
Re: Billet Specialties Wheels 15x10
I run a 15x10 with 6.5BS and had to cut the bump stops out and trim/massage the front fender wheel wells, I also have a Moser 9" standard length, UMI non adjustable control arms and an adjustable pan hard bar and everything fits no problem.
Last edited by 84 z28; 11-26-2021 at 05:32 AM.
#7
Senior Member
Thread Starter
Re: Billet Specialties Wheels 15x10
Last I remember 5.5 puts the wheel even with the fender lip, if you want the wheels inside the fender you need 6.5BS on a 15x10
I run a 15x10 with 6.5BS and had to cut the bump stops out and trim/massage the front fender wheel wells, I also have a Moser 9" standard length, UMI non adjustable control arms and an adjustable pan hard bar and everything fits no problem.
I run a 15x10 with 6.5BS and had to cut the bump stops out and trim/massage the front fender wheel wells, I also have a Moser 9" standard length, UMI non adjustable control arms and an adjustable pan hard bar and everything fits no problem.
Last edited by thatsupnow; 12-07-2021 at 10:19 PM.
Thread
Thread Starter
Forum
Replies
Last Post