V8 Radiator swap with a V6
11-15-2020, 06:44 PM
#1
V8 Radiator swap with a V6
Hey, Guys!
I have a 1989 2.8L V6 Firebird. Recently, my radiator became clogged. I found one online and purchased it. However, to my dismay, the radiator configuration is swapped, as it is actually meant for a V8 (my bad). Is it possible to put the two together? My only concern is the sharp angle it’ll cause off the water pump. Any help or know-how is deeply appreciated.
-1989Jack
I have a 1989 2.8L V6 Firebird. Recently, my radiator became clogged. I found one online and purchased it. However, to my dismay, the radiator configuration is swapped, as it is actually meant for a V8 (my bad). Is it possible to put the two together? My only concern is the sharp angle it’ll cause off the water pump. Any help or know-how is deeply appreciated.
-1989Jack
The following users liked this post:
1989Jack (03-24-2021)
The following users liked this post:
1989Jack (03-24-2021)
09-23-2021, 09:45 PM
#4
Junior Member
Join Date: Jul 2009
Location: Leominster Massachusetts
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Firebird
Engine: 2.8l V6
Transmission: Auto
Axle/Gears: 3.42
Re: V8 Radiator swap with a V6
What about the Automatic Transmission lines. My 2.8 V6 trans lines are on the passenger side.
09-24-2021, 12:10 PM
#5
Supreme Member
Join Date: Feb 2005
Location: Hawaii
Posts: 2,313
Received 159 Likes
on
148 Posts
Car: 89' Firebird
Engine: 3.4L V-6
Transmission: 700-R4
Axle/Gears: Whatever came stock!
Re: V8 Radiator swap with a V6
you'll need a V8 or 3.1 shroud along with the 3.1 hoses though
Thread
Thread Starter
Forum
Replies
Last Post