Ok how do I take this out?
08-15-2023, 10:01 PM
#1
Ok how do I take this out?
SO I am new to these cars and SBC stuff and T5 transmissions. I am taking the motor and trans out. I got the trans out and now I need to remove the engine. How do I take the hydraulic stuff apart from the motor so I can remove it? The hydraulic setup has me lost.
08-15-2023, 11:32 PM
#2
Supreme Member
Re: Ok how do I take this out?
What? Use the actual names of the parts. And/or actually open the factory service manual.
The following users liked this post:
T.L. (08-15-2023)
08-16-2023, 07:06 AM
#3
Re: Ok how do I take this out?
Sorry guys, I was so exhausted last night. I've never messed with anything other than a mechanical clutch cable operated clutch fork. With this having a hydraulic operated fork, I was a little lost on how it attaches. I watched a couple videos late last night and I think I see how it works.
08-16-2023, 09:57 AM
#4
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,117
Received 1,688 Likes
on
1,283 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Ok how do I take this out?
It's real simple.
You don't.
Unbolt the 2 bolts that hold the master cyl to the bell housing, and tie-wrap it up out of the way off to the side. Leave it fully assembled, all lines hooked up, full of fluid, etc.
You don't.
Unbolt the 2 bolts that hold the master cyl to the bell housing, and tie-wrap it up out of the way off to the side. Leave it fully assembled, all lines hooked up, full of fluid, etc.
The following users liked this post:
T.L. (08-16-2023)
08-16-2023, 02:00 PM
#5
Re: Ok how do I take this out?
Ok I feel dumb. I crawled under the car and took the 2 bolts out and that was it. So, yesterday while working on the car, it rolled off the race ramps due to my error and pinned me. I was a little shaken up yesterday so I was not thinking clearly. I've never worked on a manual trans like this before so I am learning. Thanks y'all!
08-16-2023, 04:05 PM
#6
Re: Ok how do I take this out?
Ok I feel dumb. I crawled under the car and took the 2 bolts out and that was it. So, yesterday while working on the car, it rolled off the race ramps due to my error and pinned me. I was a little shaken up yesterday so I was not thinking clearly. I've never worked on a manual trans like this before so I am learning. Thanks y'all!
The following users liked this post:
T.L. (08-16-2023)
Thread
Thread Starter
Forum
Replies
Last Post
Nutro
Tech / General Engine
24
08-15-2023 12:14 AM