TKX clutch assembly question
03-11-2023, 08:07 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2021
Location: Lancaster PA
Posts: 19
Received 0 Likes
on
0 Posts
Car: 1989 Base Firebird
Engine: fuel injected 2.8L V6
Transmission: T-5
TKX clutch assembly question
I plan on swapping a TKX 5 speed to go behind my 1977 4 bolt main 350, which I believe is a two piece rear main seal. What is a good streetable flywheel, clutch, and pressure plate combo for my application? thanks!
03-12-2023, 12:42 PM
#2
Junior Member
Re: TKX clutch assembly question
I just installed a TKX in my camaro with a sbc two piece rear main seal I used a Ram zero ballance billet steel flywheel and Ram single disc clutch disc and pressure plate , with hydraulic t/o bearing, it works great . The engine makes 540 hp at the flywheel
03-12-2023, 03:09 PM
#3
Junior Member
Thread Starter
Join Date: Oct 2021
Location: Lancaster PA
Posts: 19
Received 0 Likes
on
0 Posts
Car: 1989 Base Firebird
Engine: fuel injected 2.8L V6
Transmission: T-5
Re: TKX clutch assembly question
My numbers will be a touch below that, but a little overkill will give me some wiggle room to play if I decide to add some more! Do you have the part numbers for those parts? Thanks!
03-14-2023, 12:55 PM
#5
Junior Member
Re: TKX clutch assembly question
Here is a couple of numbers. the flywheel I used was the Ram 22 lb. one part #1501LW. if you want the 30lb. one it is #1501. The clutch I used is a Ram 88764 HDX. I don't know if you are going from an Auto to a manual But if you are swaping , you might take a look at Hawks TKX conversion kit , it has everything you need. Have fun , mine works awesome.
Thread
Thread Starter
Forum
Replies
Last Post
tonythetoad
Engine/Drivetrain/Suspension Parts for Sale
2
10-08-2023 03:57 PM