Torrington bearings and bushing depth
#1
Member
Thread Starter
Join Date: Jul 2007
Location: Utica NY
Posts: 238
Likes: 0
Received 3 Likes
on
3 Posts
Car: 88 Trans Am
Engine: 305 TBI
Transmission: 700R4
Axle/Gears: 3:42 open diff
Torrington bearings and bushing depth
Hello everyone, I’m starting to load the case with the geartrain stuff. Are my Torrington bearings on right and the bushings at the correct depth. I made a lot of beginner mistakes by not paying attention to the details when I dissembled. Here are some pics
#2
Supreme Member
Re: Torrington bearings and bushing depth
Look in your ATSG manual, Figure 178. It shows the orientation of all the thrust bearings.
The bushing installation depths look OK to me. As long as what ever rides inside the bushing is fully supported you should be fine.
Edit: The attached page from the Hydra-Matic Tech Guide is the same as that from the 700R4 manual, just better scan quality.
The bushing installation depths look OK to me. As long as what ever rides inside the bushing is fully supported you should be fine.
Edit: The attached page from the Hydra-Matic Tech Guide is the same as that from the 700R4 manual, just better scan quality.
Last edited by paulo57509; 05-03-2020 at 07:55 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Demon Z28
Pacific Northwest Region
13
08-30-2001 06:06 PM