Installing Drive shaft Firebird 3.1
#1
Junior Member
Thread Starter
Join Date: Jul 2009
Location: Poland
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991
Engine: 3.1
Transmission: Automatic
Installing Drive shaft Firebird 3.1
I've replaced U-Joints and balanced the driveshaft, now it's time to install it.
But How?
Yoke is 98 mm wide and U-Joint is 92 mm wide, how to put it straight in line?
I think last U-joint was fitted exactly to the yoke, but maybe this is only my imagination...
I don't have the old U-joints I left them at the workshop.
But How?
Yoke is 98 mm wide and U-Joint is 92 mm wide, how to put it straight in line?
I think last U-joint was fitted exactly to the yoke, but maybe this is only my imagination...
I don't have the old U-joints I left them at the workshop.
#2
Supreme Member
Re: Installing Drive shaft Firebird 3.1
The u-joint in the second photo should have come with four snap rings, yes?
Put the two extra ones on the cups for the differential yoke. The snap rings will allow the u-joint to center itself in the differential yoke.
http://www.driveshaftspecialist.com/...w%20Pinion.jpg
Put the two extra ones on the cups for the differential yoke. The snap rings will allow the u-joint to center itself in the differential yoke.
http://www.driveshaftspecialist.com/...w%20Pinion.jpg
Last edited by paulo57509; 12-05-2015 at 03:49 PM. Reason: Added photo link.
#3
Senior Member
iTrader: (1)
Join Date: Dec 2012
Location: Mattoon Il.
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 IROC-Z / T-Top -1987 GTA
Engine: 305 (LO3) _350 (L98)
Transmission: 700R4 _ 700R4
Axle/Gears: 2.73 L.S. - ???
Re: Installing Drive shaft Firebird 3.1
the caps do not go all the way to the outside of the yoke, so the yoke should be wider than the joint ... or at least it looks like the old one did not go all the way to the ends anyway
#4
Junior Member
Thread Starter
Join Date: Jul 2009
Location: Poland
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991
Engine: 3.1
Transmission: Automatic
Re: Installing Drive shaft Firebird 3.1
They didn't gave me anything more in the workshop.
It is wider, so how to center it?
It is wider, so how to center it?
#5
Senior Member
iTrader: (1)
Join Date: Dec 2012
Location: Mattoon Il.
Posts: 512
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 IROC-Z / T-Top -1987 GTA
Engine: 305 (LO3) _350 (L98)
Transmission: 700R4 _ 700R4
Axle/Gears: 2.73 L.S. - ???
Re: Installing Drive shaft Firebird 3.1
to center it, if you do not have clips, take some single strand 12 gauge wire and wrap it where the clips would go ... the clips/wire should not be there to take any stress, just to line it up ... or you could get 2 3mm washers and put one at each end while you clamp it on
Thread
Thread Starter
Forum
Replies
Last Post
MrJ
Transmissions and Drivetrain
7
06-05-2002 11:33 AM