Quick question.
06-14-2014, 01:02 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2014
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Camaro Z28
Engine: 305
Quick question.
I picked up my brand new in box Yukon Duragrip posi today for $285. The seller also gave me some used 28 spline axles but not sure if they will work for the Z28. Is there anyway to verify without pulling old ones? They measure out to 30 inches +/-
If not I will go buy shop and see if they can compare.
If not I will go buy shop and see if they can compare.
06-14-2014, 03:33 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,117
Received 1,688 Likes
on
1,283 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Quick question.
Axles for these cars are 30-5/16" if memory serves. (flange surface to tip of shaft)
06-14-2014, 08:43 PM
#4
Supreme Member
Join Date: Sep 2008
Posts: 3,777
Likes: 0
Received 0 Likes
on
0 Posts
Re: Quick question.
Do not use axles that are too short. This will pull the axle in too far and cause problems with the brakes and possibly the seals and bearings. Use the correct axles.
Thread
Thread Starter
Forum
Replies
Last Post
3.8TransAM
NW Indiana and South Chicago Suburb
1
09-27-2015 08:37 PM