t-5 rebuild question
#1
Banned
Thread Starter
iTrader: (6)
Join Date: Dec 2007
Posts: 862
Likes: 0
Received 1 Like
on
1 Post
Car: 92 25th anv camaro rs
Engine: 305 tbi
Axle/Gears: 3.08s non posi
t-5 rebuild question
ok so in the middle of my nwc t5 rebuild and ive come across something im not sure is right and that is the install of the 3/4 scryo hub. my question is how far is far enough? I have pics of where is sits now.
the guide im following doesn't say, just says use a drift that only touches the hub assembly.
these 2 pics are of the hub resting where it normally(?) is
the guide im following doesn't say, just says use a drift that only touches the hub assembly.
these 2 pics are of the hub resting where it normally(?) is
#2
Banned
Thread Starter
iTrader: (6)
Join Date: Dec 2007
Posts: 862
Likes: 0
Received 1 Like
on
1 Post
Car: 92 25th anv camaro rs
Engine: 305 tbi
Axle/Gears: 3.08s non posi
Re: t-5 rebuild question
these pics are of it pulled towards the front of the output shaft.
im concered wether or not its on to far, or not far enough (even tho it wont go on any futher) bc the front blocker ring keeps falling off.
im concered wether or not its on to far, or not far enough (even tho it wont go on any futher) bc the front blocker ring keeps falling off.
Thread
Thread Starter
Forum
Replies
Last Post