th-200c lock up kit
#1
Member
Thread Starter
Join Date: Aug 2009
Location: Chicagoland south suburbs
Posts: 195
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 Z28
Engine: 350
Transmission: Turbo 200C
Axle/Gears: 3.43
th-200c lock up kit
so I decided to quit screwing with my crossfire and im putting a 350 with aluminum 202 heads edelbrock air gap intake and a quick fuel carb. my issue is i am removing my ecm and i need to find a lock up kit for my th-200c. yes i know i am going so far with the engine and keeping the trans. unfortunatley i have the money for the engine and not the trans. i cant find a lock up kit for this any where
#2
Supreme Member
iTrader: (4)
Re: th-200c lock up kit
You can adapt any of the others to it.
It's going to be either the well-known 4-pin weatherpak connector found in the 700-R4 and 200-4R or maybe an earlier 2-pin connector. You just need to examine what wires are in the connector now and wire to whatever kit you use.
Think of it this way; if you were eventually going 700-R4, what would you do with the lockup kit? Not buy new; just adapt to a plug for the 700-R4 if it's even different.
It's going to be either the well-known 4-pin weatherpak connector found in the 700-R4 and 200-4R or maybe an earlier 2-pin connector. You just need to examine what wires are in the connector now and wire to whatever kit you use.
Think of it this way; if you were eventually going 700-R4, what would you do with the lockup kit? Not buy new; just adapt to a plug for the 700-R4 if it's even different.
#3
Member
Thread Starter
Join Date: Aug 2009
Location: Chicagoland south suburbs
Posts: 195
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 Z28
Engine: 350
Transmission: Turbo 200C
Axle/Gears: 3.43
Re: th-200c lock up kit
Thank you. I'll look for 700r4 kits. I have a 4 pin connector on it. And I fully intend to change trans in the future
Thread
Thread Starter
Forum
Replies
Last Post
Drone358
Transmissions and Drivetrain
4
12-10-2015 08:16 PM
1Aauto
Sponsored Vendors
0
09-02-2015 01:35 PM