Transmissions and Drivetrain Need help with your trans? Problems with your axle?

TV / Detent Cable Frustration

Thread Tools
 
Search this Thread
 
Old 04-24-2012, 06:44 PM
  #1  
Senior Member

Thread Starter
 
1983Chimaera's Avatar
 
Join Date: Sep 2006
Location: San Antonio, Tx
Posts: 568
Likes: 0
Received 7 Likes on 6 Posts
Car: 1988 Camaro IROC-Z
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 2.73 Positraction
TV / Detent Cable Frustration

So it seems NONE of the major parts stores carry the correct TV / Detent cable for any of the TPI engines. I have tried looking up for every year available from 1985 - 1992, F-Body and Corvette, and every cable I've tried has been utterly wrong. Autozone and Pep Boys don't carry them at all, Rock Auto and Advance Auto Parts both carry the ATP Y-363, which is the carbureted version, and O'Reilly Auto Parts has several from Pioneer, none of which actually properly fit or allow adjustment on a TPI engine. I have compared each to the stock cable on my '88 LB9 IROC-Z, and none were close. Either the catalog listings for the cables are utterly hosed, or I'm missing something. The dealerships stopped carrying TPI parts ages ago. Anyone know where to reliably find the correct cable?
Old 04-24-2012, 06:52 PM
  #2  
Member

 
Black_TA's Avatar
 
Join Date: Oct 2008
Location: New Haven, CT
Posts: 153
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983 Trans Am
Engine: 305
Transmission: Auto
Axle/Gears: Stock
Re: TV / Detent Cable Frustration

Try Napa or Ebay, or Summit. got done replacing mine, what a pain.
Old 04-24-2012, 07:02 PM
  #3  
Senior Member

Thread Starter
 
1983Chimaera's Avatar
 
Join Date: Sep 2006
Location: San Antonio, Tx
Posts: 568
Likes: 0
Received 7 Likes on 6 Posts
Car: 1988 Camaro IROC-Z
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 2.73 Positraction
Re: TV / Detent Cable Frustration

Did you run into the same issue I am? I tried 4 different cables from O'Reilly, each tiem waiting for it to be special ordered in, none ultimately worked. And yet their system has them all as for various year TPI engines. The ATP one that showed up in my Rock Auto order today is WAAAAAAAAAAAAAAAAY too long to fit my TPI, and has a connector on the end for a carbureted hookup...and yet again, shows as being the correct part for all the TPI engined cars. WTF???
Old 04-24-2012, 07:23 PM
  #4  
Member

 
Black_TA's Avatar
 
Join Date: Oct 2008
Location: New Haven, CT
Posts: 153
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983 Trans Am
Engine: 305
Transmission: Auto
Axle/Gears: Stock
Re: TV / Detent Cable Frustration

Got to match it up perfict or it will not fit.
Old 04-24-2012, 07:31 PM
  #5  
Senior Member

Thread Starter
 
1983Chimaera's Avatar
 
Join Date: Sep 2006
Location: San Antonio, Tx
Posts: 568
Likes: 0
Received 7 Likes on 6 Posts
Car: 1988 Camaro IROC-Z
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 2.73 Positraction
Re: TV / Detent Cable Frustration

Oh I know, the last thing I need is a burned up 700R4 because of a misadjusted TV cable. The first one I got from O'Reilly, the one they list for a 1988 5.0L FI Camaro, was almost the right length, but when I went to do the adjustment, the throttle went to WOT but the cable was still too slack to ratchet the adjuster. It was REAL close to the right size, but just a hair too long. Took me forever and a lot of banging my head on the counter to get that point across to the guys at O'Reillys.
Old 04-25-2012, 01:26 PM
  #6  
Moderator

 
Apeiron's Avatar
 
Join Date: Jan 2000
Location: Mercedes Norte, Heredia, Costa Rica
Posts: 20,981
Likes: 0
Received 9 Likes on 8 Posts
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: TV / Detent Cable Frustration

If you really can't find anything else you can use a universal adjustable cable.
Old 04-25-2012, 03:45 PM
  #7  
Senior Member

Thread Starter
 
1983Chimaera's Avatar
 
Join Date: Sep 2006
Location: San Antonio, Tx
Posts: 568
Likes: 0
Received 7 Likes on 6 Posts
Car: 1988 Camaro IROC-Z
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 2.73 Positraction
Re: TV / Detent Cable Frustration

Well, my last resort was a local junkyard here HAD an '88 medium orange IROC-Z with the TPI, and when I was there Monday it still had the correct TV cable on it. As I was expecting my Rock Auto order Tuesday, I didn't pull it. I went back today to pull it since the Rock Auto one turned out to be incorrect, only to find out THEY HAD CRUSHED THE #$%&^*ing CAR!! Sooooo, back to square one.
Old 06-05-2012, 04:07 AM
  #8  
Junior Member

iTrader: (1)
 
superchevy72's Avatar
 
Join Date: Aug 2006
Location: SW Florida
Posts: 56
Likes: 0
Received 0 Likes on 0 Posts
Car: 86 iroc z black/gold
Engine: LB9
Transmission: T5
Axle/Gears: 3.42 posi disk
Re: TV / Detent Cable Frustration

I know this post is a little old, but im running into the same problem. I actually work at advance auto parts and just installed the one we list for it. Mine is an 86 TPI 305, the cable i just put has the same length housing but the inside cable is waaaaaaaaay longer and has a second adjustment screw on the end that hooks to the throttle. With it adjusted to take up as much slack as i could get it without actuating the TV in the tranny its got a good 6-8 inches left over sticking out the front and its not ratcheting the regular adjuster very far at all. I just put this tranny in and i think it still needs some adjusting but with it being so much longer and having that second adjuster on it im not sure if i can get it right, might try napa tomorrow if i cant get it right. Anyways i dont recommend the Advance auto parts one, and i work there.
Old 06-10-2012, 07:40 PM
  #9  
Senior Member

Thread Starter
 
1983Chimaera's Avatar
 
Join Date: Sep 2006
Location: San Antonio, Tx
Posts: 568
Likes: 0
Received 7 Likes on 6 Posts
Car: 1988 Camaro IROC-Z
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 2.73 Positraction
Re: TV / Detent Cable Frustration

I found that RockAuto.com DOES in fact carry the correct AC Delco OEM cable. It just takes a bit of searching to find it, as it doesn't come up in the vehicle search. You have to do a part number search for the OEM part number 25521263 to find it, but it is available, and only $16.42.
Old 06-10-2012, 07:45 PM
  #10  
Junior Member

iTrader: (1)
 
superchevy72's Avatar
 
Join Date: Aug 2006
Location: SW Florida
Posts: 56
Likes: 0
Received 0 Likes on 0 Posts
Car: 86 iroc z black/gold
Engine: LB9
Transmission: T5
Axle/Gears: 3.42 posi disk
Re: TV / Detent Cable Frustration

And that number is good for the tuned port? If so that's awesome and thanks for the info!
Old 06-11-2012, 12:10 AM
  #11  
Supreme Member

iTrader: (2)
 
red rock's Avatar
 
Join Date: Sep 2009
Location: WI.
Posts: 1,591
Received 4 Likes on 4 Posts
Car: 1987 iroc
Engine: 383 TPIS intake, Dyno Don headers
Transmission: 700R4 w/Pro-built Auto/transgo 2-3
Axle/Gears: 3.27/3.70 borg warner 9 bolt
Re: TV / Detent Cable Frustration

third gen. ranch http://thirdgenranch.com/-strse-302/...ent/Detail.bok
Old 06-12-2012, 11:49 PM
  #12  
Senior Member

Thread Starter
 
1983Chimaera's Avatar
 
Join Date: Sep 2006
Location: San Antonio, Tx
Posts: 568
Likes: 0
Received 7 Likes on 6 Posts
Car: 1988 Camaro IROC-Z
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 2.73 Positraction
Re: TV / Detent Cable Frustration

Thanks red rock, but I think I'll be going with the brand new vs the 20+ year old one for only $4 more.
Old 08-25-2012, 08:32 PM
  #13  
Senior Member
iTrader: (3)
 
jtsk's Avatar
 
Join Date: Aug 2008
Location: Memphis, TN
Posts: 614
Likes: 0
Received 0 Likes on 0 Posts
Car: 1992 z28 Purple Haze
Engine: 5.7L Tuned Port Injection
Transmission: 700R4
Axle/Gears: 3.23 both spinning
Re: TV / Detent Cable Frustration

How about trying a tranny shop to see if you can order from them??
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
armybyrd
Carburetors
3
10-20-2015 03:57 AM
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
10-07-2015 12:09 PM
mcfastestZ28
Tech / General Engine
1
10-01-2015 11:23 AM
rs_z28_vert
Engine/Drivetrain/Suspension Wanted
6
09-30-2015 09:47 PM



Quick Reply: TV / Detent Cable Frustration



All times are GMT -5. The time now is 09:56 PM.