Great success!
07-18-2011, 05:41 PM
#1
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Missouri
Posts: 614
Likes: 0
Received 3 Likes
on
2 Posts
Car: Camaro RS
Engine: obd2 350 lt1
Transmission: T56
Axle/Gears: 3.23
Great success!
I finally got my wheel spacer to budge! there was no way these aren't safe I could have easily put the wheel on without the nuts and the corrosion would hold it. 
i had tried at least 5 different pullers and combinations for something to fit on the ledge and be long enough
Look Rustyness
i had tried at least 5 different pullers and combinations for something to fit on the ledge and be long enoughLook Rustyness
07-18-2011, 05:46 PM
#2
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,652
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Great success!
did it rust on, or was it wedged on because of the inner bore being too small?
07-20-2011, 12:52 AM
#4
Member
Join Date: Nov 2010
Location: Sylmar, So-Cal
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 firebird bone stock for now
Engine: 2.8L V6
Transmission: 700R4
Axle/Gears: B.W 9Bolt 3.27 Posi
Re: Great success!
ouch, that sounds frustrating. well at least you got it off now 
now to find something that doesnt let it rust together. if you find anything that helps it not stick please let me know since im planning on buying spacers in the near future and i wouldnt like it one bit if it happened to me. id probably get a blow torch or a hammer the living crap out of emm till they budged.
now to find something that doesnt let it rust together. if you find anything that helps it not stick please let me know since im planning on buying spacers in the near future and i wouldnt like it one bit if it happened to me. id probably get a blow torch or a hammer the living crap out of emm till they budged. 
Thread
Thread Starter
Forum
Replies
Last Post