HELP corvette servo snapring
10-13-2010, 04:25 PM
#1
Member
Thread Starter
Join Date: Sep 2007
Location: Bastrop, Tx
Posts: 322
Likes: 0
Received 1 Like
on
1 Post
Car: 87 Iroc-Z
Engine: 305 tpi
Transmission: 700-r4
Axle/Gears: 3.42
HELP corvette servo snapring
I just put in a corvette servo and cannot get the snapring back in. I thought I had it yesterday but it popped out and trans fluid everywhere. I've been trying to do it by getting one end in and then going around trying to get the rest in but no go. Any tips or tools I can buy to make this easier
10-13-2010, 06:58 PM
#2
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,652
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: HELP corvette servo snapring
can you wedge something along the side of the tunnel and push the cover in while you try to install the ring?
10-13-2010, 08:14 PM
#3
Member
Thread Starter
Join Date: Sep 2007
Location: Bastrop, Tx
Posts: 322
Likes: 0
Received 1 Like
on
1 Post
Car: 87 Iroc-Z
Engine: 305 tpi
Transmission: 700-r4
Axle/Gears: 3.42
Re: HELP corvette servo snapring
I finally got it in i just pinned one end into the grove with a screw driver and my bro put the other side in. Best mod ever (corvette servo and governor) it shifts amazing very smooth at low speeds but strong firm positive shifts when on the throttle.
Thread
Thread Starter
Forum
Replies
Last Post
the_hamturdler
Engine/Drivetrain/Suspension Parts for Sale
0
09-30-2015 12:50 PM
Dragonsys
Engine/Drivetrain/Suspension Parts for Sale
2
09-25-2015 03:51 PM
