Transgo a no go....
#1
Supreme Member
Thread Starter
Join Date: May 2001
Location: Orange, CT, USA
Posts: 1,074
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1983 Pontiac Firebird
Engine: 400HP 350
Transmission: 700R4
Axle/Gears: 3.42
Transgo a no go....
SO I installed transgo shift kit in my 91 700r4 about a month or two ago. First night out with the car after the motor swap and I have no 2nd gear. Anyone run into an problems with the transgo kit? I followed the direction, double and tripple checked everything. The trans was shifting fine before the install. Even installed a new seperator plate also. I'm really at a loss here. I also install a .500 boost valve, WOT 4th valve, corvette servos and accumulators.
Thanks in advance
Rob...
Thanks in advance
Rob...
#2
Junior Member
iTrader: (1)
Join Date: Apr 2008
Location: Goddard, Kansas
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 iroc-z
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.23 posi
Re: Transgo a no go....
had the same problem with my transgo when i had my tranny rebuilt. just sit in the car with the motor off and put the gas to the floor like 15 times. Its a sticky throttle valve in the tranny hope this helps
#7
Supreme Member
Thread Starter
Join Date: May 2001
Location: Orange, CT, USA
Posts: 1,074
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1983 Pontiac Firebird
Engine: 400HP 350
Transmission: 700R4
Axle/Gears: 3.42
Re: Transgo a no go....
SO I took the trans apart today. A few things I notice. The servo pin was has a bright shinny tip on it. its not black anymore..lol Second thing is, that when I dropped the VB the band anchor fell out at the same time. When I looked at the band again, I noticed that the band has slid foreward. The band is hanging about a 1/16" off the front of the drum twards the front pump. So how do I fix this? Do I have to drop the trans out of the car?
Thread
Thread Starter
Forum
Replies
Last Post
ONEFORMULAOVERALL
Auto Detailing and Appearance
10
12-18-2001 03:13 PM