View Poll Results: Will my t56 make it for 10 hours
Yes
1
33.33%
NO
2
66.67%
Voters: 3. You may not vote on this poll
Will my T56 make it???
02-10-2010, 05:11 AM
#1
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Missouri
Posts: 614
Likes: 0
Received 3 Likes
on
2 Posts
Car: Camaro RS
Engine: obd2 350 lt1
Transmission: T56
Axle/Gears: 3.23
Will my T56 make it???
I plan on driving my car for 10 hours straight and there is a bad vibration from the clutch area and since my clutch is new it must be a bent input shaft or an out of balance flywheel. I cant feel the vibration in the pedal, just through the shifter and near the bellhousing.When i took the transmission out of the old car i noticed it rounded out the pilot bearing so just my thoughts but this is caused by a bent input shaft right? thanks for any help
02-10-2010, 05:14 AM
#2
TGO Supporter
iTrader: (4)
Join Date: Jul 1999
Location: CT
Posts: 1,992
Likes: 0
Received 10 Likes
on
9 Posts
Car: 1986 Camaro SC
Engine: 305 TPI Procharged D1SC
Transmission: Tremec TKO-600
Axle/Gears: Moser 12 Bolt 3.73 posi
Re: Will my T56 make it???
could be a bent input shaft, when you changed the clutch was there a lot of play in the input shaft?
02-10-2010, 05:24 AM
#3
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Missouri
Posts: 614
Likes: 0
Received 3 Likes
on
2 Posts
Car: Camaro RS
Engine: obd2 350 lt1
Transmission: T56
Axle/Gears: 3.23
Re: Will my T56 make it???
Im not 100% sure but i remember looking at it and it couldn't have been too bad
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
1
08-08-2015 08:16 PM
