berlin305

iTrader: (2)

Trying to install a T5. and it won't go in. I wiggled and jiggled. and all that. When i pull it off it seems the throwout bearing his hanging up? Do i need a second person to pump the pedal or what? any suggestions please.

tom86iroc

iTrader: (1)

it usually takes 2 people to hold the tranny and wiggle wiggle wiggle lol did yu use a a clutch pilot tool to alighn the clutch when you installed it??

berlin305

iTrader: (2)

yea. Still no luck. only one guy doing it.

berlin305

iTrader: (2)

i took out the throw out bearing and slide it on the shaft and its probably the colprit because it slid on once then tried it again and got stuck had to wiggle it. last night i got the whole thing on and only 1/4 inch to go and it wouldn't budge no more bleh. Any suggestions more lube by putting on the input shaft?????

berlin305

iTrader: (2)

WOOT FINALLY GOT IT IN.

tom86iroc

iTrader: (1)

good job DON'T put to much lube on the input shaft you will only throw that around onto the clutch and make it slip and junk after that

berlin305

iTrader: (2)

Yea i barely put any on what i did was lube it and then took a rag and wiped it off so it had very little on it.