My LS1 Driveshaft - What do you think?
03-15-2004, 10:34 AM
#2
Supreme Member
Join Date: Mar 2001
Location: Portland, OR www.cascadecrew.org
Posts: 6,577
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Camaro RS
Engine: Juiced 5.0 TBI - 300rwhp
Transmission: T5
Axle/Gears: 3.42 Eaton Posi, 10 Bolt
looks good, too bad one one will see it.
03-17-2004, 09:44 AM
#6
Supreme Member
Join Date: Jun 2001
Location: Charleston, SC
Posts: 9,550
Likes: 0
Received 2 Likes
on
2 Posts
Car: 91 Camaro Vert
Engine: 02 LS1, HX40
Transmission: 2002 LS1 M6
lol, if you took it to a trans shop like that, i bet the tech would freak.. lol
looks good. i wonder if that effects the balance any.
looks good. i wonder if that effects the balance any.
03-17-2004, 09:56 AM
#7
Senior Member
Thread Starter
iTrader: (2)
Join Date: Dec 2001
Location: Chi Town, IL
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
Thanks!I am 99.99% sure there is no problem w/ the balance. We are talking "HAIRS" of material taken off...nothing to worry about...
lol, I wonder why some people think that...
Trending Topics
03-17-2004, 12:21 PM
#8
Banned
Join Date: Dec 2002
Location: Moving to non emission state
Posts: 828
Likes: 0
Received 1 Like
on
1 Post
Car: 86 Camaro
Engine: L98 350 bore .060 out, Carb power
Transmission: slusher 700 beatbox
wont effect the balance. ive seen people load paint on the shaft without problems. what did you use to polish it?
03-17-2004, 02:21 PM
#9
Senior Member
Thread Starter
iTrader: (2)
Join Date: Dec 2001
Location: Chi Town, IL
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
I used 3M Rubbing Compound, Tripoli, White Rouge, Swirl Remover, and Aluminum Polish...The Tripoli and Rouge didn't have that much affect on it, but they did help w/ the little corners, etc...
Used a Buffer on 1750, and a 2700rpm drill w/ a wheel for the ends.
Used a Buffer on 1750, and a 2700rpm drill w/ a wheel for the ends.
Thread
Thread Starter
Forum
Replies
Last Post