tranny mount
#1
Supreme Member
Thread Starter
Join Date: Nov 2002
Location: Castaic, CA
Posts: 1,832
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro RS
Engine: 2.8L of Raw POWER!!!
Transmission: Stick Shift
Axle/Gears: 3.42's
tranny mount
would a bad tranny mount result in hard shifting if the mount is really dead??? Every once in a while, it doesn't want to go into gear, but after a little shaking of the shifter, it goes in just fine. t also make s a clunking noise from time to time. Could this be the issue???
#3
Supreme Member
Thread Starter
Join Date: Nov 2002
Location: Castaic, CA
Posts: 1,832
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro RS
Engine: 2.8L of Raw POWER!!!
Transmission: Stick Shift
Axle/Gears: 3.42's
see, i was thinking that if the mount is gone, then the shifter does not line up in the tranny right. I don't think it has ever been replaced and I havn't had time to get under the car to look at it so I was thinking that it might be totally gone and causing my problems.
#4
Senior Member
Join Date: Jan 2003
Location: NJ
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Trans Am
Engine: 305 TBI
Transmission: th700R4
If you take off kinda hard and you hear a loud clunk like it felt like you rear got jolted your mount is bad... When i woudl take off in 1st i get a nice little clunk. I dont know about your shifting problems
#5
Supreme Member
Thread Starter
Join Date: Nov 2002
Location: Castaic, CA
Posts: 1,832
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro RS
Engine: 2.8L of Raw POWER!!!
Transmission: Stick Shift
Axle/Gears: 3.42's
definitly got the clunk, shifting problems have almost gone away totally. Only once in a while does it rear it's ugly little head. Thanks Guys
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:49 AM