hrspwr

iTrader: (3)

Hey guys, as the name suggests I need to know where to get some TPI Gaskets. I have a Hi-Flo edelbrock system and I am looking more specificaly for the upper runner to plenum gasket as the stock ones are smaller. Does anyone know where to get them? OR is there a kit that has all the hi flo's including the upper and lower in them?

I was looking at these but not sure if they are a hi flo or not (larger diameter bore)

http://www.summitracing.com/parts/ACC-74195G

Thanks in advance.

watajob

iTrader: (29)

Those will work just fine. If they don't match the runner or plenum well, get out the x-acto knife and trim the excess away.

norcalz28

iTrader: (13)

The ones you have selected are the high flow gaskets, you can tell by how little material there is showing in the image between the pairs of ports. The stock gaskets have quite a bit more meat. I am running these on my ported TPI and they work great. here is the link to the edelbrock ones


http://www.summitracing.com/parts/EDL-3866/

hrspwr

iTrader: (3)

Thanks guys. It looks like the accel ones wont work for my setup. On the fatory runners the left and right ones are different in how they seal against the lower. THe runners I have (edelbrock hi flo) the left and right side are the same. I need to use the replacement ones which are the ones that norcalz28 posted a link too.

Thanks again guys.