Trinamo

trying to get the bird running right because it was missing and smoking and so on, I've changed out the Fuel pump, fuel filter, air filter, fuel regulator, MAF, cap, rotor, plugs, wires. Its running better but is still missing/ running rough and pluming a light colored smoke when given gas, in addition to that, the rear driver side runner from the plenum to the manifold is crazy cold when the car is running. So cold it condensates like a soda out of the cooler

afremont

Injectors? Worn engine?

As for the cold runner, I don't think many here will think of that as much of a problem. I say try and figure it out then make the rest of them match. Be sure to tell us what's causing it. ;-)

Trinamo

I wouldn't mind it being cold if it were supposed to be, but its so cold its like grabbing the AC lines (no AC in my car so its not a suspect). I'm sure that it can't be good and that is why im wanting to get it figured out.

Trinamo

bump for help!

Trinamo

replaced IAC, nowhere near as much smoke but it does not want to do much, idles like crap, the runner is no longer freezing cold but it wants to die if i give it ANY gas

rough

check codes
make sure your Dizzy isnt 180degrees off
Check timing x2

navyCM

iTrader: (3)

check your voltage on your TPS, should be .54v. what color smoke?

Trinamo

IAC, TPS, new and adjusted. Timing adjusted. Plenum still cold, going to replace injectors. New symptom, plenum is full of gasoline, as in i took it off and it poured all over the top of the engine

afremont

Well, there you go. Most like coming thru the vacuum host to the pressure regulator. That would explain the cold runner.