injctors sitting awhile,, need attention before install?
#1
Supreme Member
Thread Starter
iTrader: (20)
Join Date: Aug 2007
Location: chicago
Posts: 1,111
Likes: 0
Received 1 Like
on
1 Post
Car: 87 GTA
Engine: 385 sbc
Transmission: 700r4
Axle/Gears: 2.73 posi
injctors sitting awhile,, need attention before install?
I just bought a flow matched set (by cruzin performance) of #19 injectors, bosch stockers, from a board member. theve been sitting for almost a year now, after he put 5k miles on em. I was told they were only taken off so he could upgrade to a higher # injector. Is there anything I should run through em to clean out any dust or old fuel residue that may be in there before I install them?
#2
Supreme Member
iTrader: (7)
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,675
Likes: 0
Received 108 Likes
on
66 Posts
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Re: injctors sitting awhile,, need attention before install?
Carb cleaner and make sure you bench test them before installation.
#3
Supreme Member
Thread Starter
iTrader: (20)
Join Date: Aug 2007
Location: chicago
Posts: 1,111
Likes: 0
Received 1 Like
on
1 Post
Car: 87 GTA
Engine: 385 sbc
Transmission: 700r4
Axle/Gears: 2.73 posi
Re: injctors sitting awhile,, need attention before install?
for ohms? If not how would I bench test flow?
#5
Member
Join Date: Apr 2006
Location: Utah
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Iroc Z-28
Engine: 305 TPI
Transmission: 700R4
Re: injctors sitting awhile,, need attention before install?
I will be taking my intake apart in the next few weeks as I need to fix a coolant leak. Can you send a PM my way as well or post info here? If there is something I can do other than just an Ohm test to determine the status of my injectors, I would like to do it.
#6
Senior Member
iTrader: (4)
Join Date: May 2000
Location: Oaks,Pa
Posts: 588
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 IROC
Engine: 350 HSR
Transmission: modified 700R4
Axle/Gears: 3.42
Re: injctors sitting awhile,, need attention before install?
You don't have to worry about them.They were all wrapped and left in the box that I shipped them in.They were never left in the open and they were cleaned before they were put away
Last edited by IROCZ4BD3; 07-30-2008 at 09:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post