Need Advice
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2003
Location: Warren, Oh
Posts: 93
Likes: 0
Received 1 Like
on
1 Post
Car: 89 IROC
Engine: 355,LT4 HotCam,E-tec, vortec int.
Transmission: 5 sp., Alum Driveshaft
Axle/Gears: 3.73 Posi
Need Advice
I need some advice and help.
Right now here's what I've got:
355 cu. in. tpi, large tube runners, bbk 52 mm throttle body, ported plenum, 26 lb. ford injectors, adj. fuel pressure reg. @ 47 lbs., hooker shorty headers, 5 speed, alum. driveshaft, 3.73 posi rear end.
Just got a good deal on an LT4 Hot cam, so I bought it. Also have #113 alum vet heads not yet installed.
My question is, what do I need as far as rockers, valve springs, shims and head work to complete this setup. Also, about how much hp do you think this will produce?
Right now here's what I've got:
355 cu. in. tpi, large tube runners, bbk 52 mm throttle body, ported plenum, 26 lb. ford injectors, adj. fuel pressure reg. @ 47 lbs., hooker shorty headers, 5 speed, alum. driveshaft, 3.73 posi rear end.
Just got a good deal on an LT4 Hot cam, so I bought it. Also have #113 alum vet heads not yet installed.
My question is, what do I need as far as rockers, valve springs, shims and head work to complete this setup. Also, about how much hp do you think this will produce?
Thread
Thread Starter
Forum
Replies
Last Post
HoosierinWA
Tech / General Engine
5
10-07-2015 10:15 AM