vortec head torque specs??
#1
Member
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
vortec head torque specs??
hi iam about to install a set of vortec 906 heads on my motor with the Scoggin Dickey base but can not find out how much to torque the intake bolts? i have read anyweres from 11 lbs to 35lbs on the site, does anyone know fore sure what to torque them at? would help me out alot, thanx in advance oh iam also using the fel pro 1255 intake gasket and not the factory plastic ones.
Last edited by billyhoss; 03-04-2005 at 04:06 PM.
#4
Senior Member
Join Date: Oct 2001
Location: Starkville, MS
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro Z28
Engine: 350
Transmission: 700R4
Originally posted by billyhoss
so iam guessing that would be using the plastic gaskets, anyone know about the fel pro 1255 ones? thanx again
so iam guessing that would be using the plastic gaskets, anyone know about the fel pro 1255 ones? thanx again
#5
Junior Member
Join Date: Oct 1999
Location: south
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Z28 camaro
Engine: 5.7
Transmission: 700R4
Cylinder heads and SD base
Black 91 Z28, I have been thinking of using the SD base and Vortec cylinder heads. How much would that help a bone stock 1992 Z28, L98? My car currently runs 14.60's at high 90's mph? I have the 323 gears, Borla cat-back and K-N filters in the stock air housing. Thanks
#6
Senior Member
Join Date: Oct 2001
Location: Starkville, MS
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro Z28
Engine: 350
Transmission: 700R4
I seem to have bad luck at the track so I'm probably not the one to ask but, there was a definate improvement going to the Vortec setup. It pulled harder in the upper RPM and doesn't feel like there is such a wall at 4500 RPM. I'm hoping to get to the track next week so I'll see if I can make any improvements.
Look up some info on Dyno Don (I think that's who it is) he's got a Vortec setup and runs in the 12s.
Look up some info on Dyno Don (I think that's who it is) he's got a Vortec setup and runs in the 12s.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
L98GTA87
Engine/Drivetrain/Suspension Wanted
1
08-11-2015 06:55 PM
84z96L31vortec
North East Region
1
08-10-2015 08:27 PM