350 Build with questions
02-06-2023, 02:19 PM
#1
Senior Member
Thread Starter
iTrader: (17)
Join Date: Mar 2002
Location: Rincon, Ga.
Posts: 854
Likes: 0
Received 8 Likes
on
6 Posts
Car: 91 Camaro RS
Engine: 305 TPI conversion.
Transmission: T56
Axle/Gears: 3.73 posi 4th gen rear
350 Build with questions
I have a 350tpi from a 92 z28. Im replacing the stock heads with corvette heads. I put in an lt1 cam and going to top it off with a stealth ram. I picked up ls6 springs and the retainers. Can i use the stock roller lifters and pushrods or is there a recommendation?
02-10-2023, 01:37 AM
#2
Re: 350 Build with questions
You prob can use both n be fine. But LS7 lifters are better from what most say and many use them(internals are slightly diff), got a few sets myself for future SBC projects. It's always best to check pushrod length when you change stuff up, stock ones are weak anyway. They were designed to flex a bit for noise reduction, so I always change to better pushrods.
Thread
Thread Starter
Forum
Replies
Last Post