What Header gasket for Edelbrock T.E.S
#1
Supreme Member
Thread Starter
What Header gasket for Edelbrock T.E.S
I'm getting the header ceramic coated so I'm going to need gaskets. Copper ones for sure. Trying to figure out if I go round or square port? The header is round and the head is square. Edelbrock calls for a 1.5" X 1.5" square regular material type gasket. I just can't find that exact measurement in copper. There's 1.5 x 1.46, I assume that's close enough. Thought?
#2
Member
Re: What Header gasket for Edelbrock T.E.S
Here goes a similar discussion.
https://www.thirdgen.org/forums/exha...kets-what.html
https://www.thirdgen.org/forums/exha...kets-what.html
#3
Re: What Header gasket for Edelbrock T.E.S
I'm getting the header ceramic coated so I'm going to need gaskets. Copper ones for sure. Trying to figure out if I go round or square port? The header is round and the head is square. Edelbrock calls for a 1.5" X 1.5" square regular material type gasket. I just can't find that exact measurement in copper. There's 1.5 x 1.46, I assume that's close enough. Thought?
Just use regular Felpro or something like that, but whatever you do make sure you Elongate the holes , trace it with a marker and make sure it matches the heads, cause you can blow out header gaskets pretty easily. Plus it will flow better if you elongate the gasket openings.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
3
09-10-2015 07:31 AM