Sending Unit Removal...
08-22-2014, 09:44 AM
#2
Re: Sending Unit Removal...
The two tabs sticking up are part of a lock ring that holds it in. Take a hammer and a flat screwdriver and peck them around counterclockwise. You will have to alternate from one tab to the other because it will drive the ring to one side when you work it around and bind it.
08-22-2014, 10:04 AM
#3
Re: Sending Unit Removal...
The two tabs sticking up are part of a lock ring that holds it in. Take a hammer and a flat screwdriver and peck them around counterclockwise. You will have to alternate from one tab to the other because it will drive the ring to one side when you work it around and bind it.
08-22-2014, 10:38 AM
#4
Re: Sending Unit Removal...
Looks like it's cut out from the tank? Use some penetrating oil on it. Clamp the sheet metal in a vise so you have it stabilized and can put some torque to it. If that fails drill out a few of the spots holding the outer ring to the "tank" and pry that ring away from the lock ring. You don't want to beat up the sender.
08-23-2014, 05:13 AM
#5
Junior Member
Join Date: Jul 2014
Location: caldwell idaho
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 camaro rs v6
Engine: v6 3.1
Transmission: auto
Re: Sending Unit Removal...
i had it were it was binding did u press the tabs down also you can pop one side out and then pull it off from there if that fails get some tin snips and cut it
Thread
Thread Starter
Forum
Replies
Last Post
[CA] 700R4 trans & parts
6998poncho
Engine/Drivetrain/Suspension Parts for Sale
0
09-25-2015 02:56 PM