Converting serpentine to V-belt
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Mar 2001
Location: Medford, Oregon
Posts: 3,245
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 Iroc Z L98
Converting serpentine to V-belt
I am converting my street/strip 89 Iroc from serpentine to v-belt.
My reasoning is that after swapping to an S10 manual gearbox, I will only need the water pump and the alternator, and the stock serpentine setup at that point will be overkill.
What do I need to swap to perform this conversion? I am assuming I need a new water pump since the stock water pump is reverse rotation? Do I need a different alternator?
Thanks in advance!
My reasoning is that after swapping to an S10 manual gearbox, I will only need the water pump and the alternator, and the stock serpentine setup at that point will be overkill.
What do I need to swap to perform this conversion? I am assuming I need a new water pump since the stock water pump is reverse rotation? Do I need a different alternator?
Thanks in advance!
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,732
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Converting serpentine to V-belt
How so ?
Make / buy a brace for the Alt and use a shorter serp belt The brace serves as belt tensioner like on old skool SBC .
Works without PS pump as well
Make / buy a brace for the Alt and use a shorter serp belt The brace serves as belt tensioner like on old skool SBC .
Works without PS pump as well
Last edited by vetteoz; 07-25-2013 at 08:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post