Anybody looking for vacuum pump install brackets?
06-30-2013, 09:20 AM
#1
Member
Thread Starter
iTrader: (3)
Join Date: May 2009
Location: Des Moines IA
Posts: 384
Likes: 0
Received 14 Likes
on
8 Posts
Car: 89 forrmula
Engine: 350 TBI
Transmission: T-5
Axle/Gears: 3.55
Anybody looking for vacuum pump install brackets?
http://m975.photobucket.com/albumvie...10945.jpg.html
I designed a set of vacuum pump brackets for use on a 434 I built for a guy....if you want to retain a stock GM serpentine setup, this kit uses a smog style RH bracket and the Moroso pump installs easily....this was my mockup design and requires the use of a 3 to 1 diameter reduction from crank pulley to vacuum pump pulley to reduce pump speed. The pulley is an area you'd have to decide on.....I just built the bracket kit from a water jet CNC.
I designed a set of vacuum pump brackets for use on a 434 I built for a guy....if you want to retain a stock GM serpentine setup, this kit uses a smog style RH bracket and the Moroso pump installs easily....this was my mockup design and requires the use of a 3 to 1 diameter reduction from crank pulley to vacuum pump pulley to reduce pump speed. The pulley is an area you'd have to decide on.....I just built the bracket kit from a water jet CNC.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
red90IROCls1
Transmissions and Drivetrain
10
08-25-2015 06:56 AM