1 pc rear seal to 2pc rear seal flexplate?
#1
Member
Thread Starter
Join Date: Feb 2010
Location: Dover AFB, Delaware
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Iroc-Z
Engine: 5.7
Transmission: 700r4
Axle/Gears: 3.23
1 pc rear seal to 2pc rear seal flexplate?
I'm working on a 1986 chevy camaro and I'm dropping an older style 70's 2 pc rear seal 350 in it. I'm not sure but I am under the impression that I cannot use the flex plate and starter from the 86 305? I hope so because I was planning on using most, if not all the parts off of the 305 to swap over to my 350.
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,123
Received 1,688 Likes
on
1,283 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: 1 pc rear seal to 2pc rear seal flexplate?
Right: cannot use the flex plate. Get one for 83-85 V8 Camaro/Firebird.
You can use your starter if your block has both holes that it needs. (blocks from before about 78 probably won't, 78-up probably will) If not, you can have your machine shop drill it for you.
You can use your starter if your block has both holes that it needs. (blocks from before about 78 probably won't, 78-up probably will) If not, you can have your machine shop drill it for you.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
84z96L31vortec
North East Region
1
08-10-2015 08:27 PM