I'm not sure how to hook up my new mini starter?
02-04-2013, 12:01 AM
#1
Moderator
Thread Starter
I'm not sure how to hook up my new mini starter?
My stock starter has a large stud with a nut on the end. All my wires for my starter go to this except a little purple one. Then there is a skinny stud with a nut on the end the purple wire goes to.
My new starter has two large studs/nuts. And another yellow slip fit connection. Does anyone know how I should hook it up? Here's a picture of the new starter:
Thanks guys.
My new starter has two large studs/nuts. And another yellow slip fit connection. Does anyone know how I should hook it up? Here's a picture of the new starter:
Thanks guys.
Last edited by IROCThe5.7L; 02-04-2013 at 12:07 AM.
02-04-2013, 12:35 AM
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,732
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: I'm not sure how to hook up my new mini starter?
All the wires go on the top stud of solenoid and the purple gos to the small terminal with the yellow connector
You only have to look at it
As shown in your pic , the bottom stud on the solenoid has a brass link that puts power from the solenoid
to the starter motor
As shown in your pic , the bottom stud on the solenoid has a brass link that puts power from the solenoid
to the starter motor
02-04-2013, 12:36 AM
#3
02-04-2013, 02:05 AM
#4
Moderator
Thread Starter
Re: I'm not sure how to hook up my new mini starter?
Good stuff. Thanks for the quick reply! 
Thread
Thread Starter
Forum
Replies
Last Post
