No going back now
05-02-2012, 08:15 PM
#1
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jan 2012
Location: Romney, WV
Posts: 586
Likes: 0
Received 2 Likes
on
1 Post
Car: 89 IROC Z/88 IROC Vert
Engine: 350c.i./305c.i.
Transmission: 700R4/T-56
Axle/Gears: 3.42/4.10
No going back now
I had only intended to clean up the gasket surfaces on my aluminum 113 heads but I couldn't help myself. I just got the rough cut done on 1 of them. I'll post more pics when they're finished.
05-20-2012, 06:34 PM
#2
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jan 2012
Location: Romney, WV
Posts: 586
Likes: 0
Received 2 Likes
on
1 Post
Car: 89 IROC Z/88 IROC Vert
Engine: 350c.i./305c.i.
Transmission: 700R4/T-56
Axle/Gears: 3.42/4.10
Re: No going back now
All finished! This was my first attempt at polishing anything. It took about 20hrs using a right angle die grinder with some 3M 2 inch scotchbrite discs to cut the rough cast off them and a Dremel with polishing kit and 3 different types of polishing compound to get to this point.
05-21-2012, 06:44 AM
#3
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jan 2012
Location: Romney, WV
Posts: 586
Likes: 0
Received 2 Likes
on
1 Post
Car: 89 IROC Z/88 IROC Vert
Engine: 350c.i./305c.i.
Transmission: 700R4/T-56
Axle/Gears: 3.42/4.10
Re: No going back now
Can someone move this to Detailing and appearance? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Fronzizzle
Suspension and Chassis
6
03-18-2019 08:29 PM