Distributor Advance
08-27-2008, 06:46 PM
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Jun 2007
Location: Pennsylvania
Posts: 2,359
Likes: 0
Received 5 Likes
on
5 Posts
Car: 1992 Camaro RS
Engine: Rebuilt 350 going in after paint
Transmission: WCT5, 7k & counting behind the 350
Axle/Gears: 4thgen disc rear w/ 3.73 Posi
Distributor Advance
This is probably a dumb question, and I'm pretty sure I know the answer but I wanted to double check myself. I found an 84 Berlinetta at the local U-Pull and its had the engine swapped from a v6 to a V8 judging from the VIN. The distributor in it has a vacuum advance can on it as well as an HEI coil. Am I correct in thinking that the advance can't be computer controlled on this??? I need a vac advance non-computer-controlled HEI distributor for my V8 swap and I want to make sure this one will work before I go to the trouble of pulling it. I'm 99% sure on this, I just want to be 120% sure. Thanks.
08-27-2008, 06:59 PM
#3
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Jun 2007
Location: Pennsylvania
Posts: 2,359
Likes: 0
Received 5 Likes
on
5 Posts
Car: 1992 Camaro RS
Engine: Rebuilt 350 going in after paint
Transmission: WCT5, 7k & counting behind the 350
Axle/Gears: 4thgen disc rear w/ 3.73 Posi
Re: Distributor Advance
Thanx for the quick reply.
That's what I thought. I thought it was one way or the other, not both. For whatever reason my memory just quit on me there. Maybe 5 hours the u-pull in the sun was too much?? I dunno.
Thanx again.
That's what I thought. I thought it was one way or the other, not both. For whatever reason my memory just quit on me there. Maybe 5 hours the u-pull in the sun was too much?? I dunno.
Thanx again.
Thread
Thread Starter
Forum
Replies
Last Post
