305 HO timing
#1
Member
Thread Starter
305 HO timing
Does anyone have any thoughts on timing this engine? the specs are as follows..........L69 short block w/113 alum heads valve springs to.525 lift,comp xe256H-12,comp lifters,pushrods and roller tip rockers.Weiand 8000 and Holley 6210-3 650 double pump spreadbore jetted 62 F - 83 R 5.5 power valve, slp TRI Y headers and MSD 6AL, blaster SS coil and 85551 distributor.Present timing is 10* initial advance and 25 * centrifugal advance in @4800 RPM ahead of 5 Speed man tranny..........thats the facts and it runs great but more insight might be required...Also engine vacuum is 15 to 16 in...........
#2
Supreme Member
Join Date: Jul 1999
Location: Loveland, OH, US
Posts: 18,457
Likes: 0
Received 15 Likes
on
15 Posts
Car: 4
Engine: 6
Transmission: 5
Try 12-15° initial and 36-38° "total", in a curve from 1200 to 2800 RPM; 12° vacuum on top of that.
Also try backing the jets down a couple of sizes, and raise the PV to a 10.5.
Also try backing the jets down a couple of sizes, and raise the PV to a 10.5.
#3
Member
Thread Starter
RB thanx for the input. I moved initial to about 15* ran out of pointer. changed springs to 1 light silver and 1 light blue to bring cent time in at about 3200 RPM for about 40 * total advance. No vacuum available on this distributor. No 10.5 power valves in OKC,got 9.5 but not installed yet..........thanx again
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM