rough idle/ stalls cold engine
#1
Member
Thread Starter
Join Date: Aug 2004
Location: WACO,TX.
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 berlinetta
Engine: 305
Transmission: auto
rough idle/ stalls cold engine
thought about this after i posted about the white smoke. when i start the engine it will stumble and cut off especially when i put it in gear. if i drive about a block it will run ok after that, have already cleaned the linkage on the carb and tuned up. what else should i try????
#2
TGO Supporter
Join Date: Jul 2003
Location: Grand Rapids, MI
Posts: 4,803
Likes: 0
Received 0 Likes
on
0 Posts
Car: Z28
Engine: Sb2.2 406
Transmission: Jerico 4 speed
Axle/Gears: Ford 9" 3.60
is the choke functional/adjuste properly? To me, this sounds like a choke issue.
Make sure the choke is getting proper voltage, make sure there are no gummed linkages, make sure its set correctly.
On a side note, you are pushing the gas before starting, correct?
Make sure the choke is getting proper voltage, make sure there are no gummed linkages, make sure its set correctly.
On a side note, you are pushing the gas before starting, correct?
Thread
Thread Starter
Forum
Replies
Last Post