Can I run 1.6 roller tip rockers on the 305??
#1
Member
Thread Starter
Join Date: May 2004
Location: Welland, Ont. Canada
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Z28
Engine: LG4 305 with a few modds
Transmission: T-5
Can I run 1.6 roller tip rockers on the 305??
I have a 305 Z28 and I want to know if I can run the Comp cams magunim 1.6 roller tip rockers. I have stock 305 heads with Crane single coil springs and a crane 272 H10 cam .454 lift 272 dur. Or will I have to modd the heads so the retainers wont hit??
#3
Senior Member
Join Date: Jan 2003
Location: st. Petersburg, Fla
Posts: 801
Likes: 0
Received 1 Like
on
1 Post
Car: 83 Z28
Engine: vortec 305 for now
Transmission: 5 speed
You SHOULD be fine, but check the clearance around the pushrods to be sure. Comp cams recomends this even if it's a stock application.
#6
regardless of what people say here you must check the clearance between the pushrods and the slotted holes in the heads. I needed to elongate mine. CC sells a tool for this but it involves using a dril to open the slots up. so clean up is critical. you will probably need to remove the intake to avoid contaminating your engine. Also when your checking clearance, rotate the engine through at least 2 revolutions don't just eyeball it.
Trending Topics
#8
Member
iTrader: (2)
Join Date: Jan 2010
Location: Carrollton Texas.
Posts: 446
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Camaro Z28
Engine: 305 mild build up
Transmission: 700r4
Axle/Gears: Stock
Re: Can I run 1.6 roller tip rockers on the 305??
Yes a old thread,but, what wasnt said here is that not all roller tip rockers are not the same AT ALL. some are self alinging and some are not. You need to DOUBLE check the tops of the valves to make sure you dont screw the pooch and have a valve fall into the cylinder.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM