Knock sensor and Coolant Temp switch
#1
Junior Member
Thread Starter
Join Date: Sep 2002
Location: Florida
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Knock sensor and Coolant Temp switch
I was wondering if any one knew of any new locations on the block that I could re-locate the knock sensor and coolant temp switch. I have Hooker super comp headers and they are too close to the connectors on the drivers side, so I need to re-locate them. Any ideas?
#3
Supreme Member
Join Date: Apr 2003
Location: Bonner Springs, KS
Posts: 1,751
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1995 Corvette
Engine: LT1
Transmission: 6 spd Manual
Axle/Gears: Dana 44, 3:45:1
knock sensor is right above oil pan on pass. side, cooling fan switch is in passenger side cylinder head towards the firewall.
#7
Junior Member
Thread Starter
Join Date: Sep 2002
Location: Florida
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I will have to check it out, I can't leave them where they are at now, I was thinking that the knock sensor would have to be on the block, I am hoping there are some plug holes on the drivers side that I could install them.
Thread
Thread Starter
Forum
Replies
Last Post
Chuck84TA
Engine/Drivetrain/Suspension Parts for Sale
10
07-15-2016 09:05 PM