żGasket?
06-12-2003, 11:06 PM
#3
Moderator
Thread Starter
O.K. I was hoping it might be a different size, like the FelPro:
-P/N----BORE----THICK
1003----4.166----0.041
1004----4.190----0.041
1044----4.200----0.051
1034----4.200----0.041
1094----4.100----0.015
1014----4.200----0.039
But it is listed as the factory replacement, so it's probably the 4.100/.039".
-P/N----BORE----THICK
1003----4.166----0.041
1004----4.190----0.041
1044----4.200----0.051
1034----4.200----0.041
1094----4.100----0.015
1014----4.200----0.039
But it is listed as the factory replacement, so it's probably the 4.100/.039".
06-14-2003, 10:11 AM
#4
Guest
Posts: n/a
Those are the 'performance' gaskets, if you want to call them that.
I have a set at home, I can measure them if you really want. I know though that their stock replacement SBC stuff is the blue no retorque standard issue .039 compressed. I might even be able to dig up a Fel Pro spec book.
I have a set at home, I can measure them if you really want. I know though that their stock replacement SBC stuff is the blue no retorque standard issue .039 compressed. I might even be able to dig up a Fel Pro spec book.
06-14-2003, 08:10 PM
#5
Moderator
Thread Starter
Max,
Thanks, but don't waste any extra time. That should be close enough for what I'm doing. I could find data on the "performance" gaskets, but not the "standards". I just wanted to make sure it wasn't like the GM factory 0.021" gasket for the L81.
Thanks, but don't waste any extra time. That should be close enough for what I'm doing. I could find data on the "performance" gaskets, but not the "standards". I just wanted to make sure it wasn't like the GM factory 0.021" gasket for the L81.
Thread
Thread Starter
Forum
Replies
Last Post