LT1 Intake and heads
01-20-2003, 12:29 AM
#1
LT1 Intake and heads
I have the opportunity to pick up a pair of aluminum LT1 heads and intake for very cheap. What modifications would be needed to make these fit on a standard small block besides having a hole for the ditributor drilled? Thanks for any info.
01-20-2003, 10:54 AM
#3
Supreme Member
iTrader: (1)
Join Date: Feb 2000
Location: Savannah, GA
Posts: 2,361
Likes: 0
Received 1 Like
on
1 Post
Car: 1997 Jeep Wrangler
Engine: 4.0L
Transmission: 5 speed
Axle/Gears: 8.8 rear, 4.56 gears, 4:1 transfer
The LT1 heads will need to be modified to fit a gen1 SBC. I have never done it but here's a magazine scan of someone that has.
http://www.lt1intake.com/LT1_Retrofit.htm
After that the LT1 intake will need partially modified just for the distributor hole.
http://www.lt1intake.com/LT1_Retrofit.htm
After that the LT1 intake will need partially modified just for the distributor hole.
01-20-2003, 12:13 PM
#4
TGO Supporter
iTrader: (5)
Join Date: Feb 2000
Location: St. Augustine, FL
Posts: 1,852
Likes: 0
Received 12 Likes
on
11 Posts
Car: 89 GTA
Engine: 383
Transmission: 4L80E
Axle/Gears: 12 bolt-3.73
John, is your site down? The link times out, and the email I sent you bounced back.
Sorry to hijack your thread dood.
Sorry to hijack your thread dood.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM
