Which steering seals do I need?
#1
Which steering seals do I need?
I need to get some new seals for my '89 Camaro's steering gear and there are two options for the input and pitman seals: 1) with soft ride suspension, and 2) without soft ride suspension. How do I know whether I have the soft ride suspension? My Camaro is either an RS or a Z28 model: It has a Z28 hood and rocker panel skirts, but RS tail lights and the wrong console box code list for the car (the box or console was apparently swapped out at some point in the car's life). The steering gear itself is about 2 3/4 turns lock to lock and has some indiscernible stamping on the center of the end cap.
Thanks for any help.
Thanks for any help.
#2
Supreme Member
iTrader: (1)
Join Date: Dec 2000
Location: Cincinnati,Ohio
Posts: 2,341
Received 151 Likes
on
111 Posts
Car: 1991 BandittII Firebird
Engine: 5.7 HSR
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
Re: Which steering seals do I need?
Looking on Rockauto, seems these seals are pretty inexpensive, If it were me I'd order both and see which one I would need after I've got it apart.
On a side note and correct me if I'm wrong cause I'm not a Camaro guy, I wasn't aware that the Z-28 and RS had different tail lights?
On a side note and correct me if I'm wrong cause I'm not a Camaro guy, I wasn't aware that the Z-28 and RS had different tail lights?
#4
Re: Which steering seals do I need?
My plan now is to just go ahead and take the old pitman seals out and take them into the local Carquest, because they say they have one or the other of the pitman seal kits in stock. If it matches that or not then at least I'll know what I'm dealing with. It could be that there isn't any difference between the two sets of pitman seals. I always thought the 3rd gen RS and Z28 Camaros all got the same steering boxes.
I'm leaning towards my car being an RS Camaro, because I believe all 1989 Z28 Camaros Had "IROC Z" on the rocker panel skirts and glovebox door and mine just says "Z28" on the skirts. Also it has the '91-92 hood blisters instead of the IROC louvers suggesting a previous owner took a few parts off of a 91-92 parts cars and put them on this car to try to make it into a Z28, since by then Chevy had dropped the "IROC Z" moniker and went back to calling the Z28's "Z28". Personally I would like to fix it up as one or the other rather than a combination of parts from both models.
I'm leaning towards my car being an RS Camaro, because I believe all 1989 Z28 Camaros Had "IROC Z" on the rocker panel skirts and glovebox door and mine just says "Z28" on the skirts. Also it has the '91-92 hood blisters instead of the IROC louvers suggesting a previous owner took a few parts off of a 91-92 parts cars and put them on this car to try to make it into a Z28, since by then Chevy had dropped the "IROC Z" moniker and went back to calling the Z28's "Z28". Personally I would like to fix it up as one or the other rather than a combination of parts from both models.
The following users liked this post:
91banditt2 (03-21-2023)
Thread
Thread Starter
Forum
Replies
Last Post