GM Style II Power Steering pump
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Feb 2007
Location: Tucson, Az
Posts: 659
Likes: 0
Received 0 Likes
on
0 Posts
Car: Don't
Engine: have
Transmission: it
Axle/Gears: anymore
GM Style II Power Steering pump
Is it possible to swap in a GM type 2 style power steering pump such as the one pictured, to replace our saginaw style ones?
Thanks,
Ruben
Thanks,
Ruben
#2
Senior Member
Thread Starter
iTrader: (3)
Join Date: Feb 2007
Location: Tucson, Az
Posts: 659
Likes: 0
Received 0 Likes
on
0 Posts
Car: Don't
Engine: have
Transmission: it
Axle/Gears: anymore
Re: GM Style II Power Steering pump
Anyone? The reason bieng that my P/S pump is giving out and would like to replace it with this particular unit (pictured) before I decide to go with a stock saginaw pump. What about the shaft sizes, do both style units have the same shaft diameter?
Thanks in advance,
Phoenix
Thanks in advance,
Phoenix
#3
Supreme Member
iTrader: (18)
Join Date: Dec 2007
Location: Minnesota
Posts: 1,924
Likes: 0
Received 12 Likes
on
9 Posts
Car: 84 camaro, 88 trans am, 98 camaro
Engine: Modded , stock, LSX modded
Transmission: 700r4, 700r4, t-56
Axle/Gears: 327, 308, 373
Re: GM Style II Power Steering pump
yes it can be done - you'll need a remote reservoir, pulley and bracket. heres a link to some type two brackets
http://www.alangrovecomponents.com/Power_Steering.htm
http://www.alangrovecomponents.com/Power_Steering.htm
#4
Supreme Member
iTrader: (18)
Join Date: Dec 2007
Location: Minnesota
Posts: 1,924
Likes: 0
Received 12 Likes
on
9 Posts
Car: 84 camaro, 88 trans am, 98 camaro
Engine: Modded , stock, LSX modded
Transmission: 700r4, 700r4, t-56
Axle/Gears: 327, 308, 373
Re: GM Style II Power Steering pump
sorry i was thinking 4thgen with the remount mount... what one is that pictured?
#5
Senior Member
Thread Starter
iTrader: (3)
Join Date: Feb 2007
Location: Tucson, Az
Posts: 659
Likes: 0
Received 0 Likes
on
0 Posts
Car: Don't
Engine: have
Transmission: it
Axle/Gears: anymore
Re: GM Style II Power Steering pump
Cool thanks FueledSoul . I figure I'd ask before I played guinea pig for this swap . A bit on a side note, FS, now that you mentioned the Alan Grove brackets, have you used them before? would you happen to know which particular bracket set would fit my TPI L98? As for the type II power steering bracket, would I have to modify the stock alt./ps bracket in order for this one to fit? The pump you see pictured in my 1st post is from detroitspeed.com: http://detroitspeed.com/productpages/steeringvar.htm it comes with a clip-on plastic reservoir which closely resembles our stock saginaw pumps only more 'updated' looking lol.
Thanks again for the info,
Ruben
Thanks again for the info,
Ruben
#7
Member
Join Date: Feb 2006
Location: Los Angeles
Posts: 160
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1987 Chevy El Camino
Engine: 357 CID w/Lingerfelter Super Ram
Transmission: 700-R4
Axle/Gears: GN 8.5 342's
Re: GM Style II Power Steering pump
Wondering the same question?
P/S Type-2 into L98 with stock serpentine belt setup.
P/S Type-2 into L98 with stock serpentine belt setup.
Thread
Thread Starter
Forum
Replies
Last Post