rack and pinion question
#1
Senior Member
Thread Starter
Join Date: Oct 1999
Location: Dallas, Texas
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Z28
Engine: 5.3 Gen III SBC
Transmission: 4L80E NTC 258mm Stall
Axle/Gears: Trick Chassis 9" 3.50 S-Strac
rack and pinion question
I have a PA racing tubular k-memeber with provisions for a mustang power rack. I just recently started putting everything together. I have a power rack from a 93 cobra.
The problem is that the mounting provisions that are on the K-member are too small for the rack. when the rack and the bushings are installed you can visibly see a gap between the bushing and the mounts on the K-memeber. Maybe Im just missing something here or PA messed up? I know there are a few PA racing K-members on this board with power racks did you guys encounter a similar situation?
I will try and get some pictures towmorrow. Thanks,
Chris
The problem is that the mounting provisions that are on the K-member are too small for the rack. when the rack and the bushings are installed you can visibly see a gap between the bushing and the mounts on the K-memeber. Maybe Im just missing something here or PA messed up? I know there are a few PA racing K-members on this board with power racks did you guys encounter a similar situation?
I will try and get some pictures towmorrow. Thanks,
Chris
Last edited by Chris Etemadi; 12-25-2005 at 09:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
06-13-2021 01:13 PM
lt1z350
Engine/Drivetrain/Suspension Parts for Sale
3
09-29-2015 01:50 PM