Edelbrock 3 point STB w/ SS Hood.........
#1
Moderator
Thread Starter
Edelbrock 3 point STB w/ SS Hood.........
Does anyone have this set up?
I have an ASCD SS hood on my 88 IROC w/TPI and I can not get the STB to fit. The hood hits the STB in 3 or 4 locations. I started to mod the hood, but I stopped due to the fact that I would have to take a lot of material off of it.
I was thinking of selling the Edel one and trying another brand. Anyone have any input on this matter?
Thanks in advance.
Thomas
I have an ASCD SS hood on my 88 IROC w/TPI and I can not get the STB to fit. The hood hits the STB in 3 or 4 locations. I started to mod the hood, but I stopped due to the fact that I would have to take a lot of material off of it.
I was thinking of selling the Edel one and trying another brand. Anyone have any input on this matter?
Thanks in advance.
Thomas
#4
Originally posted by 88aziroc
No I dont. I cant take pictures as it only happens with the hood closed. The only solution I see is to find a STB that has a lower "profile".
No I dont. I cant take pictures as it only happens with the hood closed. The only solution I see is to find a STB that has a lower "profile".
But doesn't the Edelbrock STB fit under a stock hood, then does the SS sit lower, or what's the deal?
#5
Moderator
Thread Starter
It fit fine under the stock hood. The SS hood has some bracing in it that face down, if you know what I mean. With the STB off, my hood closes and lines up just right. When I put it on today, it sat up about 1/4" above the fenders, right where the STB attaches.
Thread
Thread Starter
Forum
Replies
Last Post
sreZ28
Engine/Drivetrain/Suspension Parts for Sale
5
10-22-2015 08:21 AM
Hill1513
Engine/Drivetrain/Suspension Parts for Sale
0
09-19-2015 04:15 PM
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
3
09-10-2015 07:31 AM