tonys91rs

iTrader: (17)

I want to replace my fuel lines starting from the metal lines on the driverside wheel well to the fuel rail on the car. has anyone done this? im not sure what size fittings are on both lines. I was looking at the 2 foot premade lines from jegs or summit.

FSTFBDY

iTrader: (33)

Aeroquip or Russell both make fittings . They are 14mm and 16mm metric o-ring fuel fittings.

FSTFBDY

iTrader: (33)

These Guys have what you need also. Good people to buy from

9894DBH Female 14mm x 1.5" to -6: Fuel Injection Female "O" Ring Seal
9894DBJ Female 16mm x 1.5" to -6: Fuel Injection Female "O" Ring Seal
The 14mm would be for the return side, while the 16mm is for the feed side.

http://stores.ebay.com/Nook-and-Tranny-LLC

http://www.nookandtranny.com/


Dug up some old links for ya..

https://www.thirdgen.org/forums/fabr...teel-fuel.html


https://www.thirdgen.org/forums/memb...y-start-3.html

post below is directly from the link i provided

Earl's #361-9894DBH # Fuel Injection Female O-Ring Seal 14mm x 1.5 Thread (Jegs $11.99 )

Earl's #361-9894DBJ # Fuel Injection Female O-Ring Seal 16mm x 1.5 Thread (Jegs $11.99 )

Earl's #361-310006 AN Size: -06 (3/8''); 10' Foot Length (Jegs $52.99) - NOTE: You wont need more then 6 feet

92RS_Ttop

iTrader: (3)

I would look on some of the truck parts sites like LMC. Some of the 88-95 fullsize Chevy/GMC trucks with TBI came with stainless braided fuel lines from the factory. They are more than long enough, the same diameter/fittings, and probably cheaper than aftermarket.