z28cmr83

I am in the early stages of trying to determine how I am going to get my 84 Z28 fully restored with new everything. I know I don't have the complete knowledge or tools to see this type of project through so I am not going to bother attempting it. I am looking for a restoration shop that is capable of a full third generation camaro build... Engine / transmission / rear swap; update brakes / suspension, repair / replace interior. The goal would be dropping off a fair condition 84 camaro, and driving away with a new 84 camaro with some new century technology. I am looking for specific shops preferably with some third generation owner testimonials, and I am willing to travel further than the New York tri state area.

smokefan

All depends on how much you want to put into the car. I know of two shops in Connecticut that I had my car there personally for work

huberta5691

iTrader: (1)

Pauls Rods & Restos in Deer Park long island.

I had holes rusted through my floor boards on my 87 IROCZ Ttop. they cut the old boards out and put new ones in. They did a good job.

Had SFCs installed by another shop and they told me whoever did the floor boards did a great job.

Its a big shop. And great people to deal with.

dthela

check craigs list R.I. guy here that deals with nothing but gen 3's parts and restorations!

SomeGuy25thZ

How much money are you looking to spend? Search my build. I was in for over $40k and i did most of the work myself except body, paint and short block. If i had a ton of money and did it all over again, I would send my car to Detroit Speed and see if they would work on it. I've never seen them do a thirdgen but if they did it would be epic.