Third Generation F-Body Message Boards

Search: Posts Made By: GunderM
Showing results 1 to 9 of 9
Search took 0.00 seconds.
Forum: Cooling
07-27-2023, 04:11 PM
Replies: 10
Views: 889
Posted By GunderM

Re: Temp Gauge Reading High.

I replaced the thermostat, the sending unit, and the sensor on the thermostat housing.
unless that is also a sending unit.. regardless, it has been replaced.
also, my mistake on calling the sending...
Forum: Cooling
07-27-2023, 01:04 PM
Replies: 10
Views: 889
Posted By GunderM

Re: Temp Gauge Reading High.

I misunderstood the wires on top of the thermostat housing. The only temp sensor is on the block.
Forum: Cooling
07-27-2023, 12:48 PM
Replies: 10
Views: 889
Posted By GunderM

Re: Temp Gauge Reading High.

Normally hovered around 210, but I also had to replace both of the thermostats because one was bunk and the other didn't fit into the engine block.
Forum: Cooling
07-27-2023, 12:31 PM
Replies: 10
Views: 889
Posted By GunderM

Temp Gauge Reading High.

Hello. I'm replacing the *cracked* 305 block on my 82 z28 and I'm transplanting in a 350. I have run into the problem where my temp gauge in my dash is reading 250*, but when I take a reading off the...
Forum: Electronics
07-27-2023, 10:56 AM
Replies: 1
Views: 441
Posted By GunderM

Wiring question

Hello! I have a 1982 z28 and I'm swapping the engine, but I can't seem to find where these wires go. Any and all help would be appreciated. Thank you! ...
Forum: Electronics
09-05-2022, 07:25 PM
Replies: 3
Views: 279
Posted By GunderM

Re: Gauge cluster issue when light switch is activated.

I found a detailed forum after a few hours of searching. This fully encapsulates my issue along with the solution for anyone going forward.
...
Forum: Tech / General Engine
09-05-2022, 06:55 PM
Replies: 2
Views: 431
Posted By GunderM

Rough idle when warm + Dieseling

Hello.

I have a 1982 Z28 Camaro that I've swapped a cracked 305 for a moderately built up 350, but I've been struggling to get the 350 tuned properly with the Q-jet. It starts up and idols at 750...
Forum: Electronics
08-30-2022, 03:10 PM
Replies: 3
Views: 279
Posted By GunderM

Gauge cluster issue when light switch is activated.

One night while I was driving my 1982 z28 home, I ran across train tracks a bit too fast, the bumps causes something to go lose causing issues with my gauge cluster. The issue goes as follows.
...
Forum: Carburetors
08-18-2022, 11:04 PM
Replies: 1
Views: 379
Posted By GunderM

Rochester 4 Barrel Carb Problems

Greetings. I have a 1982 Z28 that I've just put a 350 into, but I'm having troubles starting the vehicle without manually pulling the throttle to add gas and holding open the butterfly valve on the...
Showing results 1 to 9 of 9


 
Forum Jump


All times are GMT -5. The time now is 02:51 AM.