Third Generation F-Body Message Boards

Search: Posts Made By: BigTiggBoy
Showing results 1 to 11 of 11
Search took 0.11 seconds.
Forum: Electronics
10-30-2005, 09:09 PM
Replies: 9
Views: 855
Posted By BigTiggBoy

This reply might be a little late and simplistic,...

This reply might be a little late and simplistic, but when I had to change a couple of the bulbs in my 3rd brake light, I made the mistake of checking the function with the hatch up and the lights...
Forum: Electronics
02-16-2005, 07:57 PM
Replies: 5
Views: 800
Posted By BigTiggBoy

According to the 86 repair manual, your next step...

According to the 86 repair manual, your next step is to disconnect C223 and check continuity between terminals B and D of the male half with the Set switch pressed.
If the switch is open, replace...
Forum: Electronics
02-11-2005, 10:34 PM
Replies: 5
Views: 800
Posted By BigTiggBoy

the rest of the steps:

the rest of the steps:
Forum: Electronics
02-11-2005, 10:32 PM
Replies: 5
Views: 800
Posted By BigTiggBoy

These are the steps for checking voltage at the...

These are the steps for checking voltage at the CC module for a 1986 cruise control. I'm not sure if it is the same for an 84 but it may help.
Forum: Tech / General Engine
03-06-2004, 10:08 PM
Replies: 4
Views: 1,302
Posted By BigTiggBoy

Code 12 means every thing is ok. If there are...

Code 12 means every thing is ok. If there are other codes stored they will flash after 12. I do not know why it would flash intermittently and not store a code, unless there is a short. You might...
Forum: Electronics
01-18-2004, 09:22 PM
Replies: 10
Views: 720
Posted By BigTiggBoy

The black box with AC on it is the cruise control...

The black box with AC on it is the cruise control module. I recently had to repair my 86 TA cruise control and I had to test voltage readings at that module.
Forum: Electronics
10-30-2003, 09:20 PM
Replies: 1
Views: 1,833
Posted By BigTiggBoy

I have an 86 TPI Trans Am and it came with a 108...

I have an 86 TPI Trans Am and it came with a 108 amp alternator stock. I'm not sure if GM used a different one for a carbed TA. I replaced it with a powermaster 140 amp.
Forum: Electronics
04-27-2003, 10:41 PM
Replies: 2
Views: 470
Posted By BigTiggBoy

I recently rebuilt the distributor in my 86 TA. I...

I recently rebuilt the distributor in my 86 TA. I replaced the Ignition Module, Radio Interference Capacitor and the pick up coil. All of these parts can be found at Advance Auto . Of course,...
Forum: Electronics
04-27-2003, 10:01 PM
Replies: 1
Views: 422
Posted By BigTiggBoy

You need to check the servo to see if it is...

You need to check the servo to see if it is functioning. Disconnect the cable that runs from the servo to the throttle body. You have to build up vacuum so start the engine and run it for about a...
Forum: Transmissions and Drivetrain
08-08-2002, 08:31 PM
Replies: 2
Views: 552
Posted By BigTiggBoy

Thanks Tom. I got a new seperator plate from...

Thanks Tom. I got a new seperator plate from gmpartsdirect.com.
FYI for anyone needing this part, if you have 6YP stamped on your transmission the part # is 8654482.
Forum: Transmissions and Drivetrain
07-30-2002, 08:53 PM
Replies: 2
Views: 552
Posted By BigTiggBoy

Removing B&M Shift Improver Kit

My transmission is out of the car and I have installed the B&M shift improver kit. After reading the post in this forum, I now want to remove it before I put the trans. back in the TA. Could someone...
Showing results 1 to 11 of 11


 
Forum Jump


All times are GMT -5. The time now is 07:47 AM.