Third Generation F-Body Message Boards

Search: Posts Made By: kosmos753
Showing results 1 to 16 of 16
Search took 0.03 seconds.
Forum: Tech / General Engine
04-30-2015, 09:21 AM
Replies: 10
Views: 7,788
Posted By kosmos753

Re: Good cam for a 350 daily driver

I am not going to Vortec heads because i already have an Edlebrock Performer intake and a brand new quadrajet that i got for $50. Bad news is i opened the box for the carb and its a quadrajet but its...
Forum: Tech / General Engine
04-28-2015, 08:52 PM
Replies: 10
Views: 7,788
Posted By kosmos753

Re: Good cam for a 350 daily driver

I changed it over planning on going to a carb but didn't have the intake carb or distributor so I put the tpi on it. I used the 305 heads because of the center bolts angle. My 86 tpi are angled the...
Forum: Tech / General Engine
04-28-2015, 08:21 PM
Replies: 10
Views: 7,788
Posted By kosmos753

Re: Good cam for a 350 daily driver

I know it's worn out (305 had more even with the spun bearing) but I didn't have the time or money to rebuild it compleatly. (Only vehicle I had at the time) I did clean everything I could without...
Forum: Tech / General Engine
04-28-2015, 03:43 PM
Replies: 10
Views: 7,788
Posted By kosmos753

Re: Good cam for a 350 daily driver

Would I need new pushrods, rocker arms or valve springs?
Sorry, I don't know to much about this part of an engine.
Forum: Tech / General Engine
04-28-2015, 03:20 PM
Replies: 10
Views: 7,788
Posted By kosmos753

Good cam for a 350 daily driver

I have a 1986 Pontiac Trans Am with a donor 350 block and the original lb9 heads and intake. Long story short is that the computer acts up every now and then and it misses or don't want to...
Forum: Transmissions and Drivetrain
04-16-2015, 12:34 PM
Replies: 3
Views: 482
Posted By kosmos753

Re: Chevy f-body T-5 with ford T-5 internals

The t-5 case is out of a v8 third gen camaro. No problem with the torque arm, the vss could be an issue and I forgot to mention it has a driveshaft with it.
Forum: Transmissions and Drivetrain
04-16-2015, 10:17 AM
Replies: 3
Views: 482
Posted By kosmos753

Chevy f-body T-5 with ford T-5 internals

I'm currently looking at a t5 as described. Was told that the input share was machined down to fit the application and has the clutch with it.
I'm looking to swap my 700r4 for a t-5 and this is one...
Forum: TPI
11-21-2014, 06:37 PM
Replies: 5
Views: 590
Posted By kosmos753

Re: Need help with tpi

Thank you for the advice, this is my first tpi setup.
Forum: TPI
11-21-2014, 06:23 PM
Replies: 5
Views: 590
Posted By kosmos753

Re: Need help with tpi

I just tried it and it did turn off. Is it normal for these relays to go bad after only 5 to 6 months? I just replaced all three of the relays because of they were broke open and allowing moisture in.
Forum: TPI
11-21-2014, 04:52 PM
Replies: 5
Views: 590
Posted By kosmos753

Need help with tpi

I have been on here for a while now but rarely post.
i have a 1986 trans am with a 5.7 block with a 5.0 heads and intake.
The original 5.0 was ruined and i got a 5.7 from an 87 full size van.
it...
Forum: Interior
08-19-2013, 10:27 PM
Replies: 1,143
Views: 131,059
Posted By kosmos753

Re: No doubt a pointless thread, but what's the weirdest thing youv'e found in your c

In my 86 Trans Am i have pulled out a five gallon buckets worth of walnuts.
In my 78 Camaro i found a bullet in the head light fuse holder.
In my 58 Willys i found 12, 38 special bullets.
In my...
Forum: V6
08-03-2013, 06:57 PM
Replies: 5
Views: 558
Posted By kosmos753

Re: Help with an '83 2.8

coil came loose from the grounding plate and the fuel pump went bad.
Forum: V6
08-03-2013, 11:25 AM
Replies: 5
Views: 558
Posted By kosmos753

Re: Help with an '83 2.8

just checked the pick-up coil (.929 K ohm)
Forum: V6
08-02-2013, 11:17 PM
Replies: 5
Views: 558
Posted By kosmos753

Re: Help with an '83 2.8

It was running good until today. i have the timing set as the label specifies under the hood and the wiring is correct. I did the work to it a little over a month ago and it is her daily driver.
Forum: V6
08-02-2013, 10:16 PM
Replies: 5
Views: 558
Posted By kosmos753

Help with an '83 2.8

Im stuck with my mothers 83 berlinetta while im putting my trans am back together. it has the carburated 2.8 in it and it just started misfiring today at a higher rpm. When its cold it will run...
Forum: Tech / General Engine
03-23-2012, 07:09 PM
Replies: 0
Views: 487
Posted By kosmos753

Just got my 86 TA, Code 36

Noticed when i got my 86 TA that it had two codes set. 36, and 42. code 42 was just a chewed wire, i hate squirrels, and i have been trying to find the cause of the code 36.
i have replaced both...
Showing results 1 to 16 of 16


 
Forum Jump


All times are GMT -5. The time now is 09:54 PM.