Search: Posts Made By: j4petro
Showing results 1 to 10 of 10
Search took 0.07 seconds.
07-15-2018, 07:12 PM
Replies: 5
Views: 519
Posted By j4petro

Re: Need help with A/C issue, please

Then it may be what the expert guy who know a lot about these cars said.
07-13-2018, 06:19 PM
Replies: 5
Views: 519
Posted By j4petro

Re: Need help with A/C issue, please

Try running the AC on low fan speed. If you only see water on hi fan speeds like I do it is because when I installed a new evap it did not come with the mesh filter type screen on the driver side and...
02-07-2013, 12:40 PM
02-07-2013, 11:51 AM
Replies: 8
Views: 846
Posted By j4petro

Re: Any good mechanic in Miami/Broward area??

Good luck, I have been looking for a year now and found none yet.
12-05-2012, 08:46 PM
Replies: 7
Views: 1,196
Posted By j4petro

Re: 700R4 Shifter Cable-Where to buy???

I purchased mine here, it was a while ago but he has always had many resources and parts that I have needed for my 87.

http://www.nookandtranny.com/
Forum: Body
04-18-2010, 01:52 PM
Replies: 2
Views: 506
Posted By j4petro

Re: Vin Etching??

Dont wast your money, get a lojack and good alarm.
Forum: Body
04-18-2010, 01:50 PM
Replies: 1
Views: 381
Posted By j4petro

Re: good body shop in Florida

Ace Sullins Carstar in Miramar is one of the best in the South Browarsd area with good prices. Been using them fro over 20 years and he does high end work the right way.
...
04-17-2010, 02:05 PM
Replies: 10
Views: 1,458
Posted By j4petro

Re: Unknown Sensor connector.

That same plug connected to the MAT sensor under my TPI plenum near the rear in front of the distributor. It was a 12 inch pigtail the connected to the main harness.
01-22-2010, 08:27 PM
Replies: 2
Views: 1,085
Posted By j4petro

Re: Z28 Rocker emblems

Are these still available?
Forum: Cooling
12-28-2009, 09:53 PM
Replies: 35
Views: 21,975
Posted By j4petro

Re: replacing heater core....big job???

Just did mine today and it was just as explained in this post. Took two of us about 5 hours to do and was a pain but worth saving the cost of having it done at a shop.
Showing results 1 to 10 of 10


 
Forum Jump


All times are GMT -5. The time now is 05:36 PM.